2018 Toyota Tacoma Recalls, Ratings & Complaints

Incident: September 30, 2026 · Filed: October 13, 2026

I have been having issues with an intermittent rain smell in my vehicle for the past few months not realizing the smell was due to water intrusion in the cabin of my truck. I own a 2018 Toyota Tacoma. As of recently the situation has been getting exceedingly worse due to stormy and rainy weather during the month of September. At this point I noticed the floor throughout my whole cabin was flooded with water. I was sure my windows were not open and my doors were closed and sealed properly. I took the vehicle to the Honda dealership and they provided me a Condition, Cause and Remedy (CCR). The CCR stated that water was entering my vehicle through the cabin vents located between my truck bed and the cabin of the vehicle. These cabin vents do not have any maintenance plan surrounding them, the seals are also not accessible or visible without complete removal of the back end of the truck. This is a manufacturer design issue and Toyota needs to warn their consumers to correct. Also because water intrudes in the vehicle it builds up moisture on the drivers windshield so you cannot see when driving early in the morning. The defroster does not help reduce visibility enough while driving. I was quoted a repair cost of $4500 by the Toyota dealership to fix. There is now mold growing through the only vehicle I own. I reached out to Toyota customer service to help get this resolved. It’s been over a week and they closed my case without providing any assistance or solution despite acknowledging the design issue. This is a common issue with Gen 3 Tacomas and driving with mold growing in your vehicle is NOT safe. I will follow up with my doctor to see if this problem is contributing to some of the current health issues I am experiencing.

Incident: August 5, 2026 · Filed: October 8, 2026

Cab air vents behind rear seat leaks causing mold to form under carpet.

Incident: May 1, 2026 · Filed: October 6, 2026

2018 Toyota Tacoma SR 4WD Double Cab, 3.5L V6 (2GR-FKS). At about 87,000 miles the check engine light came on with code P11EC, Cylinder 1 Air-Fuel Ratio Imbalance (Port). Cylinder 1 failed compression. Leakdown and coolant tests had passed earlier; borescope did not show heavy scoring. The Toyota dealer said replacing the direct injectors would fix compression (quote about $4,499). After the dealer injector repair, cylinder 1 was still 124 psi (spec about 142-180 psi), so it did not fix compression. The dealer then quoted $11,778 for a short block (+$500 incidentals) and $14,238 for an engine assembly that was not new (about 45,000 miles on the replacement discussed); adding injectors again put the short-block path at about $16,278. I was steered toward buying a new truck and had the injector work reversed because it did not fix what they said it would. Toyota Brand Engagement Center reviewed the case, called the dealer, took VINs for other Toyotas, and denied goodwill; no recall or TSB. An independent shop later pulled the engine and found the cylinder 1 exhaust valves leaking badly; cylinder wall still looked good. Machine shop valve job, new rings, injectors tested (two bad), all six replaced; repair about $8,000. Truck runs normally after. Consequences: loss of power, failed emissions monitors, risk of further engine damage if driven, high repair cost. Not a crash. This appears to be a known pattern on the 2GR-FKS in 2016-2019 Tacomas (P11EC, cylinder 1, leaking/burnt exhaust valves, often after direct-injector washdown). Toyota has not recalled; dealers stop at injectors or quote a short block/used engine, and owners pay out of warranty. Please log this under 2018 Toyota Tacoma: engine, fuel system, and valve train (cylinder head/exhaust valves, fuel injectors), so the pattern is on record. Servicing dealer: Nashville Toyota North. Toyota Brand Engagement case 260521000967.

Incident: May 5, 2022 · Filed: September 24, 2026

Rear cabin air vents not sealed properly from factory. Water leaks in and soaks interior carpet and gets moldy.

Incident: March 1, 2019 · Filed: September 21, 2026

The contact owns a 2018 Toyota Tacoma. The contact stated that while driving 65 MPH, the brake pedal was depressed and went to the floorboard, and the vehicle continued moving forward. The vehicle was taken to the local dealer and was repaired under NHTS Campaign Number: 18V888000 (Service Brakes, Hydraulic); but the contact had evidence that the repair was not performed. There was an abnormal fuel odor inside and outside of the vehicle before the failure, which continued afterwards. The manufacturer was informed through brand engagement and customer care. The failure mileage was approximately 8,000.

Incident: September 16, 2026 · Filed: September 18, 2026

I have a clear coat bubbling issue on my mirrors and also multiple clear coat stains on the hood that just developed on my Toyota Tacoma Off Road-Inferno Orange paint after two years that I own it. I called Toyota, there is no recall on my paint color, but I've viewed an online post someone has placed a lawsuit for the same reasons, but a different color. They've had a recall on white paint but not my color and I wanted to document the complaint. I called Toyota corporate and they said to file it with NTSB.

Incident: September 8, 2026 · Filed: September 8, 2026

I own a 2018 Toyota Tacoma SR, manufactured 11/2017, with factory paint code 1G3 Magnetic Gray Metallic. The factory clear coat is experiencing extensive delamination/failure on the hood and roof. This isn't isolated stone damage or normal cosmetic wear. The clear coat is failing extensively across the horizontal panels. I'm aware Toyota has previously acknowledged clear-coat peeling on Tacoma vehicles through T-SB-0004-20 and Customer Support Program 20TE02, and that there are documented complaints involving 2018 Tacomas experiencing clear-coat failure on the hood and roof. I understand my VIN may not currently fall within those programs, but I'm requesting that Toyota inspect and document the condition and consider goodwill assistance toward repainting the affected factory-painted panels. I'd also like a Toyota case number assigned to the paint failure.

Incident: July 21, 2026 · Filed: July 22, 2026

Vehicle hits a bump in the road and the check engine light comes on, followed by the gas pedal being non-responsive and an error code on the instrument panel saying “Brake Override System Malfunction. Check with dealer.” and “Pre-collision System Malfunction. Visit your dealer. ” When this occurs, have to coast the vehicle to a safe place, turn off and wiggle the Radar Control piece attached to the front grill sometimes multiple times before the truck will clear the code and accelerate. Been an ongoing issue for several months. Have replaced the front grill sensor and plate and the issue persists.

Incident: July 8, 2026 · Filed: July 19, 2026

The cab vents failed causing water to soak the carpet and pad from the back wall to the front of the cab. Mold was growing through out the the cab. Carpet & pad had to be removed. This is a known problem by dealerships and owners of Toyota Tacoma. Because the water was under the seats, trim and weather mats it went undetected exposing us to mold. Problem was reported to Toyota dealership and Toyota Corporation. A case was logged 07/10/2026 as Case # 260710001840. The resolution offered was ordering and replacing parts. All parts required for repair and on backorder. Hundreds of orders for these parts in their system. Carpet and under mat had been replaced 05/02/2025 due to a Toyota recall campaign 21TD03.

Incident: July 8, 2026 · Filed: July 13, 2026

WHAT FAILED: The clear coat finish on the exterior paint of my 2018 Toyota Tacoma has failed (cracking) in two separate locations on the same vehicle, indicating a manufacturing defect rather than normal wear. In late 2024, I discovered clear coat cracking on the roof and hood. I reported this to Toyota (Toyota case #241028000714) and paid approximately $2,000 out of pocket to have an independent body shop repaint the affected panels, as Toyota corporate declined to assist after the repair had already been performed. The clear coat is now cracking again at approximately 48,925 miles, this time on the cab in the pillar/trim area between the tops of the doors and the roofline. The vehicle and affected areas are available for inspection upon request. SAFETY IMPACT: This is a cosmetic exterior paint/clear coat defect. I have not identified any impact on vehicle operation, structural integrity, or visibility, and I am not aware of any safety risk to myself or others resulting from this issue to date. I am reporting it to document a recurring defect pattern on this vehicle. REPRODUCED/CONFIRMED BY A DEALER OR SERVICE CENTER: The 2024 occurrence was inspected and repaired by an independent body shop (not a Toyota dealer). The current occurrence has been reported to Toyota corporate (Toyota Brand Engagement Center) along with photographs, but has not been physically inspected by a Toyota dealer. INSPECTED BY MANUFACTURER, POLICE, OR INSURANCE: Toyota corporate reviewed photographic evidence of the current issue through my correspondence with the Toyota Brand Engagement Center, which I have asked to be linked to prior case #241028000714. Toyota has not physically inspected the vehicle. This is not a crash-related issue, so no police or insurance inspection has occurred. WARNING LAMPS OR PRIOR SYMPTOMS: Not applicable. This is a cosmetic paint/clear coat defect rather than a mechanical or electronic system issue, so there were no dashboard warning lamps or system messages