2022 Chevrolet Suburban Recalls, Ratings & Complaints

Incident: September 29, 2026 · Filed: September 30, 2026

The fuel pump control module failed, causing the engine to stop.

Incident: September 21, 2026 · Filed: September 25, 2026

The contact owns a 2022 Chevrolet Suburban. The contact stated that while driving at an undisclosed speed, the engine failed after the message “Drive Carefully - Reduce Acceleration” was displayed and the vehicle then came to a sudden stop. The vehicle was unable to accelerate, and the engine seized. The contact replaced the battery, but the failure persisted. The vehicle was towed to an independent mechanic, and the vehicle was diagnosed with a blown engine. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline. The failure mileage was 125,000.

Incident: September 17, 2026 · Filed: September 24, 2026

Intermittant slow, jerking when shifting gears. In 4wd rear wheels locked up on right hand turn, sliding through intersection. No warning or failure lights. Needs inspection and repair.

Incident: July 23, 2026 · Filed: September 18, 2026

While towing a light trailer (~3,000 lbs) through the mountains on an interstate, my 2022 Suburban with the 6.2 engine suddenly got hot and shut off. There were no symptoms of the engine having any issues, it had been running well the whole trip. The temperature gauge went from normal to very hot in a very short time. I was not able to get it to a pull-off area and was stranded partially in the right lane of the interstate with several collision close calls. This problem was later determined by the dealer to be the common crank bearing issue for this model engine.

Incident: September 17, 2026 · Filed: September 18, 2026

2022 Chevrolet Suburban, 3.0L Duramax diesel, 10-speed automatic, purchased March 2022, approx. 122,000 miles. In early August 2026 the transmission began shuddering at low speeds. Reported to the selling and servicing Chevrolet dealer on 08/11/2026 at 118,892 miles. No transmission diagnosis was performed; the dealer's written estimate recommended spark plugs on a diesel engine. The condition worsened. On 09/17/2026 the dealer verified the concern and documented a "very harsh shift which would continue until 5th gear" when accelerating, and found the transmission fluid "heavily contaminated with metal and clutch material." The dealer recommended transmission replacement at customer expense and stated GM Special Coverage N242454441 (transmission control valve wear, companion to Safety Recall 24V-797 / GM N242454440) does not apply because DTC P0747 is not set, although that bulletin lists harsh shifting as an effect of the worn control valve. The control valve body has not been inspected. GM's recall filing states this wear can cause harsh shifting and in rare cases momentary rear wheel lock-up. No warning lamps or messages appeared before the harsh shifting. No crash, fire or injury. The vehicle and transmission are at the dealer and available for inspection; a GM TAC/FSE inspection has been requested. Filing so NHTSA has a record of a 2022 Suburban diesel showing the recall symptom and being denied inspection on the basis of the P0747 code alone.

Incident: April 13, 2026 · Filed: September 2, 2026

This problem isn’t just the 6.2L engine. My 22 Suburban has the 5.3L and had engine failure on the freeway going 70 mph in April 2026. Loud noises and loss of power. Towed to dealership and was confirmed that it was the same issues as the 6.2L. The dealership only replaced certain components (gears, rods, camshaft etc.) Parts replaced and vehicle returned a month later but still loss of power and bad idle. New dealership in May 2026, replaced same parts, said faulty parts were used at previous dealership. Vehicle repaired and returned in June2026, a day later new code for service transmission now code thrown and parking break not working. Returned to dealership and said it was a fuel pump module? failed. No vehicle for 3 months and lots of headaches. This recall needs to be extended to the 5.3L engine as well. Needs full replacement, not just repaired. My vehicle still doesn’t run great but Chevy will not honor anymore repairs.

Incident: May 15, 2026 · Filed: September 1, 2026

The contact owns a 2022 Chevrolet Suburban. The contact received an unknown recall. The contact stated that the vehicle was taken to the dealer, and while parked at the dealer, it was determined that there were metal shavings in the oil and that the engine needed to be replaced. The vehicle was repaired, but a failure occurred 4,000 miles, two months later. The contact stated that while driving 55 MPH, the vehicle lost power and then stalled. The vehicle stopped in the middle of the highway and was inspected. The vehicle was then towed to a different dealer where it was diagnosed and determined that the engine had failed and needed to be replaced. The vehicle was not yet repaired. The vehicle was towed back to the dealer where it was diagnosed and determined that the engine needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was approximately 53,000.

Incident: July 14, 2026 · Filed: August 31, 2026

I am submitting a safety complaint regarding our 2022 Chevrolet Suburban equipped with the 6.2L L87 engine. The vehicle is subject to GM Product Safety Recall N252494000 / NHTSA Recall 25V-274. Our Suburban underwent GM's required recall inspection, including the Picoscope inspection. The engine passed the inspection and the engine oil type was changed in accordance with GM's recall procedure. Since passing that recall inspection, we have experienced the following issues: On XXX, at approximately 40,527 miles, while we were in [XXX], the vehicle displayed a reduced-acceleration warning and check-engine light and experienced significant acceleration problems and loss of reverse. We took the vehicle to Essenlohr Motors, a Chevrolet dealer in [XXX]. The dealer diagnosed a P0700 condition/control solenoid stuck off and repaired the transmission valve body under GM warranty. I understand this incident was diagnosed as a transmission issue, and I am including it as part of the vehicle's recent history rather than asserting that it was caused by the L87 engine defect. The dealer's repair order documents both the check-engine condition and our report of the reduced-acceleration warning. On XXX, after we had returned home to [XXX] from our trip to [XXX], the Suburban had 41,798 miles on it. We drove approximately 2 miles from home when a “Low Engine Oil–Add Oil” warning appeared. We immediately returned home and parked the vehicle. After allowing it to sit for approximately 15 minutes, we checked the engine oil and there was no oil registering on the dipstick. We saw no evidence of an external oil leak on the garage floor or underneath the vehicle. Rather than continuing to drive it, we had the Suburban towed to Wiers Chevrolet in [XXX]. The dealer confirmed that the engine was approx. two quarts low on oil and indicated that there was no apparent leaks. They performed an oil change and started a 6,000 mile oil consumption test. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Incident: May 20, 2026 · Filed: August 31, 2026

The contact owns a 2022 Chevrolet Suburban. The contact stated that while driving at highway speeds, the vehicle shut off while displaying "Service Transmission Now Unable to Shift Soon" and "Engine Power is Reduced" warning messages. The vehicle was towed to a dealer where it was previously inspected under NHTSA Campaign Number: 25V274000 (Engine and Engine Cooling); however, no repairs were performed. After remaining at the dealer for nearly eight weeks, the engine was replaced under warranty. A few weeks after the replacement, the same warning messages were displayed on the instrument panel upon startup. The contact attempted to drive the vehicle; however, the vehicle failed to exceed 20 MPH and was towed back to the dealer. While attempting to drive the vehicle into the service bay, the technician experienced severe hesitation and engine stalling. During diagnostic testing, a large amount of metal shavings was discovered in the oil filter, and the vehicle was diagnosed with the same engine failure as before. The vehicle was repaired; however, the contact refused to take possession of the vehicle due to safety concerns. The manufacturer was notified of the failure, and a case was filed. The failure mileage was 61,000.

Incident: July 3, 2026 · Filed: August 31, 2026

Just for information purposes, I have been an ASE certified Master automotive technician for 30 years. As I was accelerating onto the highway, my transmission downshifted hard, throwing everything forward. It then went into limp mode with “ses” light on. I was able to drive it home stuck in one gear. The next morning I tried to drive the truck. It had reverse but when trying to go forward, the transmission was stuck in between gears and fighting itself. I manually shifted into low gear and it seemed to clear up the binding. I drove the truck up and down my driveway which is about a half mile long. No more “ses” light but when I went to park it, there was no movement in reverse. As I researched the problem I found the recall information on the valve body. I called several dealerships to find a service writer that had experience with these transmission issues. The truck was towed to a dealership that knew about this recall. Their technician checked for codes but there were none. It seems these trucks reset or “lose” codes when the ignition is turned off. He checked the fluid and decided that the reverse clutch must be burned up. They quoted a transmission replacement at $6500. I asked if they had driven the truck forward at all to reset any trouble codes. The truck was “unsafe” to drive due to the random harsh downshift and erratic behavior. I went there(putting myself in danger) to drive the truck to reset any trouble codes. Within a mile the truck did the same thing. It stored a code P2732. I was informed that GM would not do anything for me unless there was a P747. After reasoning with the service manager and also GM, it was obvious I was out of luck. I had the truck towed home and removed the transmission pan. The fluid was clean and there was no debris. The problem is in the defective valve body from GM but since it didn’t have the code P0747 I’m stuck having to repair it myself. The truck has 126k miles still well within the extended service range.