2013 Ram 3500 Recalls & Complaints

Incident: October 8, 2026 · Filed: October 8, 2026

The contact owns a 2013 Ram 3500. The contact stated that the vehicle became uncontrollable and was difficult to maneuver while driving on the road. The vehicle was taken to a local dealer, where the contact was informed that the part was to repair the vehicle was on back order. While driving approximately 45 MPH, the vehicle crashed into a ditch caused by a failure with the drag link. The contact stated that the shift interlock was fractured, causing the gear shifter to detach while the vehicle was driven. The vehicle became stuck in park(P). The vehicle was towed to a mechanic and was repaired with an aftermarket part. The contact stated that the dealer had not repaired the vehicle causing the failure. The customer care department was contacted but was unable to assist with the dealer. The contact was concerned that the aftermarket part might not meet the OE standards. The approximate failure mileage was 155,000.

Incident: May 11, 2015 · Filed: August 22, 2025

The contact owns a 2013 Ram 3500. The contact stated that while attempting to sell the vehicle, the contact discovered there was a discrepancy in the mileage. The contact stated that the Carfax mileage was 47,029, and on March 10, 2015, the mileage was recorded at 49,873, and nine days later the mileage was recorded at 47,019.

Incident: January 13, 2018 · Filed: January 13, 2025

The contact owns a 2013 Ram 3500. The contact stated while driving 65-68 MPH over a bumpy road surface, the steering wheel and the front end of the vehicle shuddered significantly. The contact decelerated, exited the freeway, and pulled over to the shoulder of the road. The contact was able to continue driving. The vehicle was taken to the dealer, where the contact was informed that the vehicle had experienced the death wobble. The dealer diagnosed the vehicle and determined that the upper ball joints and control arms needed to be replaced. The dealer replaced the upper control arms. The vehicle was then taken to an independent mechanic, where the upper ball joints were replaced. The contact stated that the failure recurred several times while driving. The contact stated that the upper and lower ball joints, the control arms, the bushings, and other unknown parts were replaced several times; however, the failure persisted. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 100,000.

Incident: January 25, 2019 · Filed: November 20, 2023

I HAVE BEEN HAVING PROBLEMS WITH A RECALL ISSUED BY NHTSA. THE RECALL WAS V06 DRAG LINK. WHEN THE RECALL WA PREFORMED, THE ALIGNMENT NUTS ON THE DRAG LINK WERE WELDED SO THE COULDN'T COME LOOSE. I'VE HAD TO HAVE MY TRUCK REALIGNED 2 TIMES SINCE THE DRAG LINK NUTS WERE WELDED. AS OF RIGHT NOW THE NUTS ARE NOT WELDED AND THE INTEGRITY OF THE DRAG LINK IS COMPROMISED. I'VE HAD IT INTO 3 DIFFERENT INDEPENDENT REPAIR SHOPS AND EACH SAY THAT WELDING THE NUTS SHOULD ONLY BE A TEMPORARY FIX NOT A PERMANENT FIX. SINCE THE WELDING, I'VE HAD STEERING ISSUES WITH MY TRUCK WHICH IS WHY I'VE HAD IT IN THE REAPIR SHOPS. I FEEL THAT THE DRAG LINK NEEDS A TOTAL REPLACEMENT AND NOT A BANDAID FIX. I'VE CONTACTED FCA 2 TIMES AND HAVE A CASE NUMBER, #[XXX]. THE CALLS MADE WERE ON OCT. 10 & OCT 24. I'VE ALSO CONTACTED THE THE RAM DEALERSHIP IN MY AREA WHERE I GET SERVICE DONE AND HAVE "0" RESPONSE FROM THEM. I WOULD LIKE TO KNOW WHAT I CAN DO TO GET THIS ISSUE RESOLVED. THE WELDING OF A STEERING COMPONENT (DRAG LINK) IS NOT A FIX. I HAVE HAD STEERING ISSUES AND DEATH WOBBLE OCCUR SINCE THIS RECALL WAS COMPLETED. I'VE HAD IT IN FOR 2 ALIGNMENTS. I'M WORRIED FOR THE SAFETY OF MY FAMILY NOT HAVING THIS ISSUE TAKEN CARE OF. PLEASE ADVISE ON MY NEXT STEPS THANKS FOR YOUR ATTENTION. RECALL - V06 NHTSA 19V-021 INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Incident: November 12, 2023 · Filed: November 16, 2023

When having to brake hard, the lining of the pressure line from the pump to the hydro booster comes apart and causes the brakes to not work and the power steering to act up. The plastic lining shoots into the booster causing it to fail. They don’t make a replacement line so I was forced to fabricate one. Very expensive fix.

Incident: March 30, 2023 · Filed: April 17, 2023

Truck was repaired June 2019. They welded the jam nut which made it impossible to get an alaignment.Been having a open claim with Chrysler Jeep and Dodge going on 2 years per claim #78469040 Front Suspension Track Bar Frame Bracket ( vehicle recently started to do the death wobble again)

Incident: March 9, 2018 · Filed: March 9, 2023

The contact owns a 2013 Ram 3500. The contact stated that the tailgate would fall open unintendedly while driving and the tailgate would fail to close securely after several attempts. The contact stated that the failure occurred several times. The vehicle was taken to the dealer, where the tailgate was replaced under NHTSA Campaign Number: 19V347000 (Latches/Locks/Linkages); however, the failure reoccurred while the contact was attempting to drive off the dealer's parking lot. The vehicle remained at the dealer. The contact stated that the following day, the dealer was able to close the tailgate securely; however, the failure persisted while driving. The dealer notified the manufacturer of the failure, but no assistance was provided. The vehicle was not repaired. The failure mileage was approximately 4,000.

Incident: July 8, 2019 · Filed: January 27, 2023

Took truck to Mac Haik here in Houston to perform the recall.The jam nut on drag link was welded,which was not a fix.Went back after being told truck can't be aligned with the drag link being welded.Was told I'd have to pay out of pocket for the weld to be cut,which sense have led to other issues with the front suspension. Attached is docs concerning this matter .....I been having a open claim with Dodge Chrysler and Jeep for over 2 years.Is there any remedy for such a problem?

Incident: May 8, 2022 · Filed: December 29, 2022

The contact owns a 2013 Ram 3500. The contact stated that the vehicle was taken to the dealer to be repaired under NHTSA Campaign Number: 15V541000 (Steering); the contact stated that after the repair while driving at an undisclosed speed, the vehicle experienced the death wobble. The contact stated that the track bar was recently replaced; however, the failure persisted. The contact stated that excessive force was needed to maneuver the vehicle. The contact inspected the vehicle and became aware of holes in the steering bracket. The contact called the dealer and attempted to purchase the brackets however, the contact was unsuccessful in retrieving the repair parts. The vehicle was not diagnosed or repaired. The manufacturer had not been made aware of the failure. The approximate failure mileage was 149,000.

Incident: December 15, 2021 · Filed: May 6, 2022

Driving the Ram on the expressway, my son in law went from 70 miles per hour ( 30 lbs of boost) to 45 miles per hour (10 LBS of boost). So thankful it did not cause a rear end accident. Taking it in to the dealership to get fixed they said it was the turbocharger actuator then gave me the price.$11,314.32. I have a trucking company so I bought the part for $1409.71 and my diesel mechanic did the repairs for a fraction of the cost. Then I get a letter in the mail from FCA US LLC Customer Center Reimbursement, for this same problem BUT on my 2015 Ram 3C63R3EL4FG523122. My issue is this it's the same part, for the 2013 and 2015 Ram Pickup truck 3500. It should have been a recall not an extended warranty for all the vehicle years that this part is in their trucks . Someone is going to get hurt. The Customer Center declined the reimbursement and to even discuss the situation they hung up on me for the representative told me I was wasting his time and he had other calls to take.