2006 Jeep Liberty Recalls, Ratings & Complaints

Incident: September 5, 2026 · Filed: September 12, 2026

The front passenger side lower ball joint corroded, failed, or detached while I was driving, causing the front of the car to basically fall onto the tire/steering to fail. I had to immediately pull over right before entering the highway as it was undriveable. Thankfully I wasn’t going fast bc this could’ve caused a crash or flipped my car. There was a recall for this exact issue for 800,000 Jeeps of the same make, model, and year, but this exact VIN wasn’t included in the recall. No warning lights or symptoms appeared prior to this occurring. I am asking for an expansion of this recall notice to include my VIN as clearly this issue is one in the same.

Incident: August 1, 2026 · Filed: August 3, 2026

Two of my sons were involved in a rollover accident. Thankfully, they are ok with minor injuries and bruising. However, none of the airbags deployed.

Incident: July 15, 2026 · Filed: July 21, 2026

ball joint recall was issues and done on paper in August 2006 on the Jeep liberty. Both ball joint have failed on this vehicle at different times this year while driving the vehicle and Jeep has declined to take any responsibility in any way. This is a major safety concern as any kind of speed while this occurs would be catastrophic. I suspect that Jeep submitted that the recall was fixed when in fact it was not and documents were falsified.

Incident: April 13, 2024 · Filed: April 13, 2026

The contact owns a 2006 Jeep Liberty. The contact stated that while driving at an undisclosed speed, the steering wheel was loose, with a clunking sound coming from the steering wheel. The vehicle was taken for inspection and failed the inspection. The vehicle was diagnosed by a certified mechanic, and the contact was informed that the driver's side ball joint was detaching and needed to be replaced. The vehicle was taken to another certified mechanic to be repaired. Two years later, the steering was loose again. The vehicle was taken for inspection, and it failed the inspection again. The vehicle was not repaired. The contact researched and found information about NHTSA Campaign Number: 06V288000 (Suspension); and associated the failure with the recall. The dealer was contacted and confirmed that the VIN was not included in the recall. The manufacturer was not made aware of the issue. The failure mileage was 87,803.

Incident: March 6, 2026 · Filed: March 9, 2026

Odometer Fraud. The contact purchased a 2006 Jeep Liberty on January 16, 2026, from a used car dealer. While attempting to obtain insurance for the vehicle, the insurance company discovered a mileage discrepancy. The insurance company informed the contact that the vehicle could not be insured due to the mileage discrepancy. The dealer was contacted however, while attempting to retrieve a Carfax report; Carfax could not provide the report. At the time of the purchase, the mileage was 143,000; however, the insurance company discovered that the mileage was 168,000 in 2020.

Incident: January 25, 2026 · Filed: February 7, 2026

The front lower ball joints have repeatedly failed under recall. The dealer says I now have to pay to have it repaired properly, under recall

Incident: November 5, 2025 · Filed: January 27, 2026

Vehicle: 2006 Jeep Liberty VIN: [XXX] Summary: The front lower ball joint on my 2006 Jeep Liberty failed while the vehicle was in normal use. This failure matches the defect described in NHTSA Recall 06V288000 (Chrysler F23), which involves corrosion and separation of the front lower ball joints. My VIN does not currently show this recall as open, but the failure occurred exactly as described in the recall documentation. Details: In November 2025, the front end of the vehicle collapsed due to a lower ball joint separation. The joint failed without warning, causing loss of steering control. The vehicle had to be towed home by AAA. The failure is consistent with the recall condition involving water intrusion, corrosion, and separation of the lower ball joint from the steering knuckle. The vehicle still has other open recalls (fuel tank and rear lower control arms), but the front lower ball joint recall does not appear as open in the NHTSA VIN lookup. I believe the recall may have been incorrectly marked as completed in the past, or the original repair was not performed or not performed correctly. The defect has clearly recurred. Safety Concern: This is a serious safety hazard. The ball joint separation caused sudden loss of steering and could have resulted in a crash. The defect is identical to the condition described in Recall 06V288000. Requested Action: I am requesting that NHTSA review this case and require Chrysler/Stellantis to perform the recall repair for the front lower ball joints, as the defect has reoccurred and the recall never expires. I also request verification of whether the recall was ever properly completed on this VIN. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Incident: November 5, 2025 · Filed: November 12, 2025

The contact owns a 2006 Jeep Liberty. The contact stated that while driving approximately 20-25 MPH, the front control arm fractured. The front wheel seized, and the vehicle drove into a driveway. There were no warning lights illuminated. The vehicle was towed to the residence. The local dealer was contacted and suggested an appointment, and that the rear control arm was not covered under warranty. The contact was informed about NHTSA Campaign Number: 13V252000 (Fuel System, Gasoline, Structure) and NHTSA Campaign Number: 18V278000 (Suspension). The vehicle was not diagnosed or repaired. The manufacturer was contacted and referred the contact to the local dealer for assistance. The approximate failure mileage was 180,000.

Incident: September 1, 2025 · Filed: September 9, 2025

Every time I pump gas it spits back out at me. No matter what I do. This is completely unacceptable and dangerous

Incident: August 17, 2025 · Filed: August 19, 2025

The contact owns a 2006 Jeep Liberty. The contact stated that while reversing, the contact noticed an abnormal sound before the vehicle stopped. The contact stated that upon inspecting the vehicle, the front of the vehicle had lowered unintendedly. The contact noticed that the front lower ball joint had detached and separated from the spindle. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The dealer was made aware of the failure. The contact referenced an unknown recall; however, the VIN was not included in the recall. The manufacturer was not made aware of the failure. The failure mileage was approximately 214,564.