2009 Ford Fusion Recalls, Ratings & Complaints

Incident: September 18, 2026 · Filed: October 6, 2026

The contact owns a 2009 Ford Fusion. The contact stated that while driving 20 MPH and coming to a complete stop at a traffic light, the brake pedal was depressed but traveled down to the floorboard. The contact shifted into neutral(N) and continued to pump the brake pedal until the vehicle responded. The vehicle was taken to the dealer to be repaired under NHTSA Campaign Number: 19V904000 (Service Brakes, Hydraulic). The brake calipers and the brake master cylinder were replaced, and the ABS module was cleaned; however, the failure persisted, and the contact was advised to retrieve the vehicle. The contact believed that the ABS module replacement was required to repair the vehicle, but the dealer denied additional repairs.

Incident: August 21, 2026 · Filed: September 3, 2026

Dear NHTSA, The braking system failed which was covered by Ford Safety Recall 19S54 with NHTSA campaign #19V904000 at 37,750 miles. After research and finding the label of the ABS Hydraulic Control Unit still on the vehicle, being manufactured 07/12/2008, picture attached, it turned out to be the original HCU, whose failures were the reason for the Safety Recall. A Ford dealer had performed software evaluation of the ABS HCU and determined replacement of unit not necessary. This was done on 4/14/2021 at 17,606 miles along with break fluid change to DOT4 and reservoir cap change. Unfortunately my wife just went through a four-way stop intersection when the break pedal went to the end of its movement without being able to stop. No injuries or crashes involved. According to all sources read, this was caused by the ABS HCU valve being stuck open after attempting to brake on the slippery road during rain. The car is no longer safe to drive and sitting in front of our home. Asked Ford Motor Co to take care of this incomplete repair by the Ford dealer and replace the HCU but they say it’s no longer their responsibility. My understanding is that with a safety recall, they are to fix the issue as long as the vehicle is still around. They don’t agree. Can you help with this situation? Thank you! Note: I tried to upload pictures of ABS HCU and VIN labels on vehicle but failed after a number of retry attempts. If you need them I can try another way. Let me know.

Incident: May 20, 2026 · Filed: July 20, 2026

my brakes had went out while i was driving home from work

Incident: April 16, 2026 · Filed: April 20, 2026

The contact owns a 2009 Ford Fusion. The contact stated that the vehicle was taken to an independent mechanic for brake repairs, and after the repairs, the brake pedal felt spongy. The independent mechanic performed further inspections and diagnosed the vehicle with insufficient brake pressure due to a failure of the ABS hydraulic control unit. The manufacturer was notified of the failure. The contact related the failure to NHTSA Campaign Number: 19V904000 (Service Brakes, Hydraulic); however, the VIN was not included. The approximate failure mileage was 110,000.

Incident: January 30, 2026 · Filed: February 11, 2026

The contact owns a 2009 Ford Fusion. The vehicle was repaired under NHTSA Campaign Number: 19V904000 (Service Brakes, Hydraulic), but the failure occurred. When the vehicle was retrieved from the dealer, the contact was informed that the vehicle had passed an inspection. The brake pedal was depressed approximately seventy percent down for the brakes to engage. The contact stated that the brake pedal was soft while depressed. No warning lights were illuminated. The vehicle was taken back to the dealer, but it was unknown if the vehicle was diagnosed. The contact was informed that the rear calipers needed to be inspected. However, the contact was unsure if the rear calipers were inspected. The contact stated that the vehicle remained at the dealer unrepaired and was awaiting a flush of the braking system. The dealer made the manufacturer aware of the issue. The zone manager informed the contact that a satisfaction program had expired. No additional assistance was provided. The failure mileage was approximately 95,000.

Incident: August 1, 2025 · Filed: October 8, 2025

The ABS warning light came on while driving, and the brakes began to feel unsafe during normal stops. I later learned there is an open recall for the ABS module on my vehicle. When I took it to the dealership, they refused to perform the recall repair unless I paid out of pocket for a new ABS control module, even though the recall notice mentions this component. The issue affects braking performance and safety, especially on wet roads. The ABS system continues to malfunction, and the dealership’s refusal to complete the recall repair leaves the vehicle unsafe to drive.

Incident: August 12, 2025 · Filed: August 12, 2025

My car's brake pedal started not working properly. When trying to brake, the brake pedal goes down further than what it is supposed to and it takes longer than normal to brake, causing almost wrecks. It happens suddenly when trying to brake sometimes and it is very scary. There was a previous recall on the brake lines and it said they needed to be flushed out and all. I had this done to my car before and thought everything was okay. But it is not. I called Ford and they said there is currently a Customer Satisfaction Program that covers the repair of the Hydraulic control unit but it is limited to vehicles under 15 years old. My car is 16 years old so it does not qualify for this program. I asked why this wasn't a recall because it is such a big safety issue and they stated they couldn't make it a recall, it would have to be reported and issued from NHTSA. If the brakes/brake pedal is messing up and this is a known issue, then the vehicles' age should not matter. It should be recalled and fixed because this is such a huge safety concern and obviously a defect when manufactured. I don't have another car to drive and I'm sure there are numerous others in this same position and I feel it is imperative that this be looked into further and issued as a recall so people can remain safe and I'm sure this would save lives. I almost ran into a car today and it is extremely hazardous. It is very dangerous and scary and there is no warning light or anything indicating anything is wrong until driving it and it randomly happens. I have taken care of my car and had the previous recalls fixed but Ford knows this is an issue and very dangerous so it seems clear this needs to be issued as a recall.

Incident: August 4, 2025 · Filed: August 7, 2025

I have recall 19S54 and called Ford. They made an appointment with Downtown Ford, Charleston, WV. The dealership said ford declined my recall repair due to not being able to get their machines to get any codes from my car. The ABS light is on. My mechanic said Ford should fix their recall. The recall says the D03 fluid must be changed to DOT 4 even if no problem found and if problem detected how to fix it! Ford declined because they can't get code reader to work on my car. They said it is a Preexisting Condition! My car is old but only has 24,800 miles and has been kept inside in a heated garage. The Downtown dealership said their hands are tied and would love to make my car safe. Their phone number is 304 344 1601. Please help me get my car fixed!!! I have called Ford multiple times and no help due to not having the codes from the dealership. Thanks!!!!

Incident: November 26, 2024 · Filed: November 26, 2024

I have noticed for some time in our 2009 Ford Fusion purchased used that the brake travel was longer than it should be. This results in the need to anticipate braking quicker and react faster to allow appropriate time to slow down. In doing some research I discovered a Ford recall 19S54 which was apparently replaced by a Ford CSP 21N11. I made an appointment to have this issue addressed by a Ford dealership and they said that the CSP expired in 2022 and the vehicle is no longer covered despite the persistence of the safety issue and the fact that it has not been repaired for this known problem. With a significant issue, such as braking, I believe the expiration should be extended to allow for Ford owners to have this known safety issue addressed appropriately by Ford.

Incident: January 1, 2020 · Filed: October 25, 2024

The contact owns a 2009 Ford Fusion. The contact stated while driving 35-45 MPH, the brake pedal was depressed; however, the vehicle was slow to respond. The check brakes system message was displayed. The ABS warning light was illuminated. The contact received notifications of NHTSA Campaign Numbers: 19V904000 (Service Brakes, Hydraulic) and 21V158000 (Air Bags); however, the parts to do the recall repairs were not yet available. The local dealer was contacted. The dealer completed the air bag recall and diagnosed the vehicle and determined that the brake module and HECU module were corroded. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue, but no additional assistance was provided. The failure mileage was approximately 96,970. Parts distribution disconnect.