2011 Mazda MAZDA3 Recalls, Ratings & Complaints

Incident: July 1, 2026 · Filed: July 16, 2026

The contact owns a 2011 Mazda Mazda3. The contact stated that while operating the vehicle, the front driver’s side seat wobbled and was unsecured. The vehicle was taken to the local dealer, who determined that the front driver’s side seat lifter link was inoperable and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was provided. The contact was informed that the VIN was not included in NHTSA Campaign Number: 17V082000 (SEATS). The contact stated that the vehicle had experienced the failure listed in the recall. Additionally, the contact stated that the dashboard was melted and warped. The contact was concerned that the front air bags would not properly deploy due to the warped dashboard housing in the front driver and passenger side air bags. The failure mileage was 167,850.

Incident: January 20, 2026 · Filed: January 28, 2026

The airbag system failed to deploy during a major accident I was in, where my car rolled multiple times, and the collision that totaled my car. This includes the front airbags, impact sensors, and/or the airbag control module not activating. The vehicle is currently in the possession of the insurance company and can be made available for inspection upon request. During the crash, no airbags deployed, which significantly increased the risk of serious injury or death. The lack of airbag deployment left my partner and me completely unprotected at the moment of impact, including the number of times we rolled, seriously putting our safety at severe risk The vehicle is no longer drivable. The police report notes that the airbags did not deploy. The vehicle is in the process of inspection by my insurance adjusters as part of the total‑loss evaluation. The manufacturer has not yet inspected the airbag system, but the vehicle can be made available if Mazda requests an inspection. There were no warning lights, messages, or symptoms indicating an airbag or safety system issue before the crash. The airbag system gave no indication of malfunction before the failure occurred.

Incident: November 21, 2025 · Filed: November 24, 2025

I was driving it and randomly the AT and TC , and check engine light came on and the car went into limp mode, after doing some research it appears to happen to all 2009-2011 Mazda3's and it's a safety hazard. It's a safety hazard because of when it's stuck in limp mode sometimes if your at a light or something it'll start shifting and if you're not holding the brake completely down it will make the car lurch forward like 2-3 feet more if you don't react fast enough. This is a serious problem as it can cause a wreck. And you never know when it's going to happen there will be no symptoms it will just go into limp mode sometimes it'll rapidly go in and out and I'm sure that's causing damage to my transmission. Please make Mazda recall the TCM part and replace it. Thank you so much for taking the time to read my complaint/safety issue. Have a good day or night!!!

Incident: May 1, 2017 · Filed: September 16, 2025

The instrument panel above the information display in my 2011 Mazda3 has warped and created a visible gap, which is a known defect previously covered under Mazda’s Special Service Program A9 (SSP A9). While originally described as a cosmetic issue, in my vehicle the gap now allows engine odors and emissions to enter the passenger cabin. This condition presents a safety and health risk to occupants. My daughter drives the vehicle daily to college and is regularly exposed to these fumes. To confirm the problem, I used a Temtop M2000C Advanced Air Quality Monitor and recorded the following CO₂ levels inside the cabin compared to outside air: - Outside vehicle (baseline): 348 ppm - Inside after 1 minute: 436 ppm - Inside after 5 minutes: 1,027 ppm - Inside after 15 minutes: 1,645 ppm According to the monitor’s air quality guide, 1,501–2,500 ppm CO₂ is classified as “Unhealthy.” These readings indicate a measurable intrusion of emissions into the cabin. Mazda Customer Experience has acknowledged the vehicle is outside the SSP A9 warranty window and denied repair assistance, but I believe this issue is no longer cosmetic. The defect now creates a condition that may adversely affect occupant health and safety and should be considered under NHTSA’s authority for potential investigation. The vehicle can be inspected upon request. A Mazda dealer (Group 1 Mazda Denton, Texas) has provided a repair estimate of $1,307.77 for instrument panel replacement. Photos of the gap and air quality readings are available.

Incident: August 10, 2024 · Filed: August 16, 2024

The car is jerking and check engine light is on. Also when you are stopped and press on the gar it takes a bit to get speed. The transmission control module needs to be replaced. There seems to be this issue on many mazda's just not sure why a recall hasn't been done for this case.

Incident: October 13, 2022 · Filed: January 22, 2024

Defective Driver's seat construction made by Mazda Mfg Corp. I was the first person to report this cheaply made driver's seat failure to Mazda Corp in Irvine, CA in early 2015 or 2016. Recall was finally issued a year afterwards because Mazda dragged their feet, and only after I threatened to sue them if I was ever in an accident, and the seat was to totally fall apart, and maim me for life did they finally take action. The Recall fix (cheap bandaid clamp that again failed because seat frame welds had failed as well) was never done right, and as a result the seat totally fell apart, and Ed Howard Lincoln Mazda of Sarasota, FL didn't want to do anything further at that point (cost out of pocket wise). I was told by a different Mazda Dealership in Ft Myers, FL that that defective seat should have been totally replaced if they would've handled it correctly. So Ed Howard Lincoln Mazda really screwed me on that one! As related to the 2.5L Mazda engine, I also had/have a engine failure part there as well. It's called the ENGINE COOLANT (WATER) OUTLET FLANGE, and the bottom left hand bolt (1 of 4 bolts total) that's suppose to hold this cheap plastic part in place was stripped (over-torqued) at the production assembly line time that the engine was made (put together). Now the cheap plastic replacement part is leaking again from the same lower left hand corner, and this is a well Known Ford & Mazda 2.5L engine failure design as stated in many a Mazda online forum! This also should have been recalled, as now my 2011 Mazda 3 is down again. Engine overheated again on Oct 13, 2023. Prior repair to replace this defective Flange was done in Feb or Mar of 2022. Cheap Plastic parts put on a Metal engine just don't work well at all. Common Physics would tell you that! I have documents in my storage unit if you need them.

Incident: May 18, 2022 · Filed: March 2, 2023

My seat lifter broke causing the driver's seat to rock back and forth. I brought my vehicle to my local dealer on 05/18/2022 to have an outstanding NHTSA recall 17V-082 performed to repair the issue. I was informed that the necessary part to repair the seat was on backorder and there was no ETA, but that I would be contacted when a part was available. Over the following nine months, I periodically followed up to see if they had received the part, culminating with being told by the dealer on 03/02/2023 that the part order was canceled and flagged as no longer available and that I needed to contact Mazda directly. I then called Mazda, who told me that the part was indeed marked as retired and advised that I seek an aftermarket replacement, of which none is available. They did check in my local area and found only one remaining part in a dealer's inventory, which I'll be driving to on 03/11/2023 to have the repair done. There has been no consideration made by Mazda for my safety while driving the vehicle, and for anyone still requiring this repair, the part is "retired" and no longer available from Mazda for an open recall.

Incident: September 1, 2021 · Filed: December 21, 2022

The contact owns a 2011 Mazda Mazda3. The contact stated while driving at an undisclosed speed, the clutch became inoperable. There were no warning lights illuminated. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was notified but no additional assistance was provided. The failure mileage was approximately 80,000.

Incident: August 1, 2022 · Filed: December 14, 2022

The contact owns a 2011 Mazda Mazda3. The contact stated that while driving at an undisclosed speed, the steering wheel started to shake. The contact stated that the tire pressure warning light and check engine warning lights intermittently illuminated. The vehicle was taken to the dealer where it was diagnosed that the suspension, seat connector, and an unknown software needed to be updated. The contact then stated that due to the suspension failure, the tires were worn prematurely. The vehicle was repaired; however, the failure recurred. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure and the contact was advised to call the NHTSA Hotline for assistance. The failure mileage was approximately 170,000.

Incident: November 24, 2022 · Filed: December 4, 2022

Transmission Control Module Failed while driving. Do to this there was a loss in ability to properly shift which made driving dangerous. There has been several online reports and accounts about this specific car signaling a check engine light coming on, AT light coming on and when other indirect or incorrect codes like Solenoid (A), (B), or (C). Luckily I did not crash therefore, I have no inspections have been necessary by police or insurance representatives. But I did have my local mechanic shop diagnose the problem. I noticed the car shifted a little weird but, no lights, warning, or messages came prior to failure. In the first couple of minutes prior to the first failure, was a simple check engine light which read a code for the Solenoid. Local shop diagnosed Transmission Control Module Failure and proceeded to "fix" the module. Second Failure was mid drive, AT light came on and a few minutes into my drive back home to park the car, it failed.