NHTSA vehicle safety data
1997 International Harvester 8200 Recalls & Complaints
The 1997 International Harvester 8200 has 2 NHTSA recall campaigns on file as of October 21, 2026. try.vin has no NHTSA owner complaints on file for the 1997 International Harvester 8200. Recall repairs are usually free at an authorized International Harvester dealer.
NHTSA recall and complaint data for the 1997 International Harvester 8200. Recall data is refreshed daily from NHTSA.
NAVISTAR/REAR AXLE
NHTSA #96V240000 · Suspension — Rear · NHTSA notice
Reported November 27, 1996 · INTERNATIONAL TRUCK AND ENGINE
Potentially affected: 233 vehicles
Owners notified December 13, 1996 · Vehicles built September 3, 1996 – October 2, 1996 (per NHTSA)
Defect description
VEHICLE DESCRIPTION: SCHOOL BUSES AND HEAVY DUTY TRUCKS EQUIPPED WITH REAR AXLE ASSEMBLIES PRODUCED BY DANA SPICER. CERTAIN REAR AXLE ASSEMBLIES WERE IMPROPERLY HEAT TREATED WHICH COULD ALLOW PINION BREAKAGE AT THE PINION THREADS.
Safety consequence
CRACKS CAN INITIATE AND RESULT IN SEPARATION OF THE THREADED END OF THE PINION RESULTING IN SEPARATION OF THE YOKE AND DRIVE LINE FROM THE REAR AXLE INCREASING THE RISK OF A VEHICLE ACCIDENT.
Manufacturer remedy
DEALERS WILL REPLACE THE REAR AXLE CARRIER/PINION ASSEMBLY.
Notes
OWNER NOTIFICATION:OWNER NOTIFICATION WILL BEGIN DECEMBER 20, 1996. NOTE:OWNERS WHO TAKE THEIR BUSES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT NAVISTAR AT 1-800-448-7825.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
NAVISTAR/EATON/DRIVE AXLE HOUSING
NHTSA #96V233002 · Suspension — Rear · NHTSA notice
Reported November 22, 1996 · INTERNATIONAL TRUCK AND ENGINE
Potentially affected: 1,133 vehicles
Owners notified December 3, 1996 · Vehicles built April 16, 1996 – October 16, 1996 (per NHTSA)
Defect description
THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION.
Safety consequence
THIS LOCKING TAB PREVENTS THE WHEEL BEARING NUT FROM LOOSENING DURING VEHICLE OPERATION. IF THIS TAB IS DEFORMED, THE NUT CAN LOOSEN ALLOWING THE WHEEL TO SEPARATE FROM THE AXLE INCREASING THE RISK OF A VEHICLE ACCIDENT.
Manufacturer remedy
DEALERS WILL REPLACE THE DRIVE AXLE HOUSING NUTS WITH A CONVENTIONAL WHEEL NUT HARDWARE SYSTEM.
Notes
OWNER NOTIFICATION:OWNER NOTIFICATION BEGAN DECEMBER 10, 1996. NOTE: OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT NAVISTAR AT 1-800-448-7825.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
Other International Harvester 8200 model years
Check your 1997 International Harvester 8200 VIN
Not every recall applies to every VIN in a given year. Enter the 17-character VIN from your International Harvester 8200 at nhtsa.gov/recalls to see whether your specific vehicle has an unrepaired recall.
Check an International Harvester VIN