NHTSA vehicle safety data
1995 International Harvester 8200 Recalls & Complaints
The 1995 International Harvester 8200 has 3 NHTSA recall campaigns on file as of October 21, 2026. try.vin has no NHTSA owner complaints on file for the 1995 International Harvester 8200. Recall repairs are usually free at an authorized International Harvester dealer.
NHTSA recall and complaint data for the 1995 International Harvester 8200. Recall data is refreshed daily from NHTSA.
Service Brakes, Hydraulic — Foundation Components — Hoses, Lines/Piping, and Fittings
Reported August 2, 1995 · INTERNATIONAL TRUCK AND ENGINE
Potentially affected: 278 vehicles
Owners notified August 15, 1995 · Vehicles built April 1, 1995 – May 1, 1995 (per NHTSA)
Defect description
THESE VEHICLES WERE BUILT WITH AN IMPROPERLY PLUMBED BRAKE SYSTEM WHICH AFFECTS THE BRAKING ON THE REAR AXLE WHEN RUNNING EITHER BOBTAIL OR PULLING A TRAILER.
Safety consequence
THIS CONDITION CAN AFFECT THE STOPPING ABILITY OF THE VEHICLE BECAUSE THE FRONT STEER AXLE BRAKES AND TRAILER'S BRAKES WOULD BE DOING MOST OF THE BRAKING. INCREASED STOPPING DISTANCES WOULD BE REQUIRED CAUSING ACCELERATED WEAR ON THE STEER AXLE AND THE TRAILER BRAKES.
Manufacturer remedy
NAVISTAR DEALERS WILL INSPECT VEHICLES AND REPAIR BY INSTALLING BRAKE LINES AND FITTINGS AS REQUIRED.
Notes
SYSTEM: BRAKES; HYDRAULIC; LINES; NONMETALLIC.VEHICLE DESCRIPTION: TRUCK TRACTORS BUILT WITH PROPORTIONAL BRAKES.NOTE: OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME, SHOULD CONTACT NAVISTAR AT 1-800-448-7825. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
Steering — Linkages — Tie Rod Assembly
Reported May 9, 1995 · INTERNATIONAL TRUCK AND ENGINE
Potentially affected: 196 vehicles
Defect description
DURING ASSEMBLY, THE TIE ROD END NUTS WERE NOT PROPERLY TORQUED. EXTREMELY LOW TORQUE CAN ALLOW MOVEMENT BEWEEN THE BALL STUD AND THE TIE ROD ARM CAUSING DAMAGE.
Safety consequence
THIS CONDITION CAN AFFECT THE DRIVER'S ABILITY TOSTEER THE VEHICLE INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.
Manufacturer remedy
DEALERS WILL CHECK THE TORQUE ON THE BALL STUDS OF THE SUSPECT AXLES AND BRING THE TORQUE UP TO ROCKWELL'S SPECIFICATIONS.
Notes
SYSTEM: STEERING; LINKAGES; TIE ROD; END.VEHICLE DESCRIPTION: MEDIUM AND HEAVY DUTY TRUCKS EQUIPPED WITH ROCKWELL NON-DRIVING FRONT AXLES, MODELS FF-942, FF-961 OR FL-941.NOTE: IF YOUR VEHICLE IS PRESENTED TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND THE REMEDY IS NOT PROVIDED FREE OF CHARGE WITHIN A REASONABLE TIME, PLEASE CONTACT NAVISTAR AT 1-800-448-7825. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
Vehicle Speed Control — Accelerator Pedal
Reported October 7, 1994 · INTERNATIONAL TRUCK AND ENGINE
Potentially affected: 6,449 vehicles
Owners notified October 17, 1994 · Vehicles built January 1, 1994 – June 1, 1994 (per NHTSA)
Defect description
THE BASE OF THE ELECTRONIC ACCELERATOR PEDAL IS MADE OF DIE CAST ALUMINUM. THE BASE MOUNTS DIRECTLY TO THE CAB FIREWALL. THE CAB FIREWALL IS NOT RIGID ENOUGH OR FLAT ENOUGH AT THE MOUNTING SURFACE, CAUSING STRESS ON THE ACCELERATOR BASE THAT WILL CAUSE THE MOUNTING PADS ON THE BASE OF THE PEDAL ASSEMBLY TO FAIL AND TOTALLY SEPARATE FROM THE FIREWALL.
Safety consequence
THIS CAN CAUSE LOSS OF SPEED CONTROL, DRIVER DISTRACTION, AND RESULT IN AN ACCIDENT.
Manufacturer remedy
DEALERS WILL INSPECT THE ACCELERATOR PEDAL ASSEMBLY AND INSTALL A PLATE BETWEEN THE ACCELERATOR MOUNTING BASE AND THE FIREWALL ON THOSE UNITS WHERE THE BASE IS NOT BROKEN AND HAS NO VISIBLE SIGNS OF A CRACK. IF THE BASE IS BROKEN OR CRACKED, THE ACCELERATOR ASSEMBLY WILL BE REPLACED WITH A NEW REDESIGNED ACCELERATOR PEDAL ASSEMBLY.
Notes
SYSTEM: FUEL; THROTTLE LINKAGES AND CONTROL; PEDAL.VEHICLE DESCRIPTION: TRANSIT BUSES, SCHOOL BUSES, HEAVY AND MEDIUM DUTY TRUCKS.NOTE: IF THE VEHICLE IS PRESENTED TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND THE REMEDY IS NOT PROVIDED FREE OF CHARGE WITHIN A REASONABLE TIME OR THE REMEDY DOES NOT CORRECT THE DEFECT, PLEASE CONTACT NAVISTAR AT 1-800-448-7825. ALSO, CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
Other International Harvester 8200 model years
Check your 1995 International Harvester 8200 VIN
Not every recall applies to every VIN in a given year. Enter the 17-character VIN from your International Harvester 8200 at nhtsa.gov/recalls to see whether your specific vehicle has an unrepaired recall.
Check an International Harvester VIN