NHTSA vehicle safety data
2015 Altec Digger Derrick Recalls & Complaints
The 2015 Altec Digger Derrick has 8 NHTSA recall campaigns on file as of October 21, 2026. try.vin has no NHTSA owner complaints on file for the 2015 Altec Digger Derrick. Recall repairs are usually free at an authorized Altec dealer.
NHTSA recall and complaint data for the 2015 Altec Digger Derrick. Recall data is refreshed daily from NHTSA.
Cable Entry Step May Detach
NHTSA #25V562000 · Structure — Frame and Members · NHTSA notice
Reported August 29, 2025 · Altec Industries, Inc.
Potentially affected: 903 vehicles
Repair completion: 67.77% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN-3246 · Owners notified October 24, 2025
Defect description
Altec Industries Inc. (Altec) is recalling certain 2011-2025 Aerial Device, Digger Derrick, and 2022-2025 Service Body vehicles. The cable step wire rope assembly may be improperly secured, which can allow the cable entry step to detach from the vehicle.
Safety consequence
A cable step that fails during use increases the risk of injury.
Manufacturer remedy
Altec will provide owners with instructions to inspect the cable crimps. If the cables are improperly crimped, Altec will provide instructions and a kit to replace the wire rope assemblies. Repairs will be performed free of charge. Owner notification letters were mailed October 24, 2025. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN-3246.
Load May Fall Due to Incorrect Winch Holding Valve
NHTSA #23V636000 · Equipment — Mechanical — Winch · NHTSA notice
Reported September 14, 2023 · Altec Industries, Inc.
Potentially affected: 53 vehicles
Repair completion: 37.74% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign MAB 3113 · Owners notified September 22, 2023
Defect description
Altec Industries, Inc. (Altec) is recalling certain 2004-2023 DL42 and DL45 Digger Derricks. The incorrect hydraulic load holding valve may have been installed, which can cause the winch to lower uncontrollably and the load to fall.
Safety consequence
An uncontrolled load falling increases the risk of injury to personnel or others nearby.
Manufacturer remedy
Altec will replace the load holding valve, free of charge. Owner notification letters are expected to be mailed October 6, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is MAB 3113.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.nhtsa.gov.
Incorrect Slope Indicator Placard
NHTSA #19V365000 · Equipment — Other — Labels · NHTSA notice
Reported May 13, 2019 · Altec Industries Inc.
Potentially affected: 1,036 vehicles
Repair completion: 57.05% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN 719 · Owners notified July 2, 2019 · Vehicles built March 15, 2009 – April 15, 2019 (per NHTSA)
Defect description
Altec Industries Inc. (Altec) is recalling certain 2009-2019 DL/DM, DL/DMB, DH, D/2/3/4, and DC Digger Derrick vehicles. The slope indicator placard card may falsely indicate that the unit could be used without leveling on a 5 degree slope.
Safety consequence
An operator may improperly set up the unit, making the unit unstable, thus increasing the risk of injury.
Manufacturer remedy
Altec will notify owners, and issue CSN 719 to owners, instructing them to remove the incorrect placards, free of charge. The recall began July 2, 2019. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 719.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Pedestal Tube may Crack
NHTSA #19V127000 · Equipment · NHTSA notice
Reported February 27, 2019 · Altec Industries Inc.
Potentially affected: 14,389 vehicles
Repair completion: 70.32% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN 713 · Owners notified April 3, 2019 · Vehicles built October 15, 2003 – February 22, 2019 (per NHTSA)
Defect description
Altec Industries, Inc (Altec) is recalling certain 2003-2019 Altec DL/DM, DL/DMB, and DC Digger Derrick vehicles. The pedestal tube welds may crack over time.
Safety consequence
Unrepaired cracks may result in failure of the pedestal and uncontrolled movement increasing the risk of injury.
Manufacturer remedy
Altec will notify owners and will provide repairs as necessary and a reinforcing kit. The recall began April 3, 2019. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 713.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Undersized Wiring May Cause Fire
NHTSA #18V791000 · Electrical System — Wiring — Fuses and Circuit Breakers · NHTSA notice
Reported November 9, 2018 · Altec Industries Inc.
Potentially affected: 331 vehicles
Repair completion: 58.61% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN 703 · Owners notified January 9, 2019 · Vehicles built February 29, 2008 – June 30, 2018 (per NHTSA)
Defect description
Altec Industries, Inc. (Altec) is recalling certain 2008-2018 Altec AC18, AC23, AC26, AC30 and AC38 Cranes and D2B, D3A, D4A/B, DL42B, DT65 and DT80 Digger Derrick vehicles. The wiring on the 12V circuit from the chassis battery to the Power Distribution Module (PDM) may be insufficiently sized.
Safety consequence
The insufficiently sized wire may overheat, increasing the risk of fire.
Manufacturer remedy
Altec will notify owners, and dealers will replace the wiring to the PDM, with a larger wire and/or replace the circuit breaker, free of charge. The recall began January 9, 2019. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 703.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Zone Rating Error may cause Loss of Load Control
NHTSA #18V745000 · Electrical System — Software · NHTSA notice
Reported October 22, 2018 · Altec Industries Inc.
Potentially affected: 175 vehicles
Repair completion: 49.71% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN 700 · Owners notified December 12, 2018 · Vehicles built November 3, 2014 – May 31, 2018 (per NHTSA)
Defect description
Altec Industries (Altec) is recalling certain 2014-2018 DHH and DHB Digger Derrick vehicles. The Zone Rating System may not alert the operator that the load being handled exceeds the rated load for the unit's specific position.
Safety consequence
Without an alert, there is a greater risk of unit instability or a loss of load control, increasing the risk of injury.
Manufacturer remedy
Altec will notify owners and dealers will update the Zone Rating System software, free of charge. The recall began December 12, 2018. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 700.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Unintended Winch Movement
NHTSA #16V536000 · Equipment — Mechanical — Winch · NHTSA notice
Reported July 14, 2016 · Altec Industries Inc.
Potentially affected: 252 vehicles
Repair completion: 52.78% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN 635 · Owners notified August 26, 2016 · Vehicles built December 26, 2015 – March 30, 2016 (per NHTSA)
Defect description
Altec Industries Inc. (Altec) is recalling certain model year 2015-2016 Aerial Devices and Digger Derrick vehicles equipped with front bumper winches or capstans, manufactured December 26, 2015, to March 30, 2016. The affected vehicles have a hydraulic motor whose shaft may fail resulting in unexpected movement of the winch or the capstan.
Safety consequence
Unexpected winch movement may increase the risk of injury.
Manufacturer remedy
Altec will notify owners, and dealers will replace the hydraulic motor, free of charge. The recall began on August 26, 2016, 2016. Owners may contact Altec customer service at 1-205-991-7733. Altec's number for this recall is CSN 635.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Improperly Torqued Rotation Bearing Fasteners
NHTSA #16V307000 · Equipment · NHTSA notice
Reported May 16, 2016 · Altec Industries Inc.
Potentially affected: 63 vehicles
Repair completion: 84.13% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN 633 · Owners notified June 2, 2016 · Vehicles built October 1, 2014 – April 30, 2016 (per NHTSA)
Defect description
Altec Industries Inc. (Altec) is recalling certain model year 2014-2016 DL and DM Digger Derricks manufactured October 1, 2014, to April 30, 2016 with the digger booms mounted in the corner. The rotation bearing fasteners on the affected vehicles may not have been properly torqued.
Safety consequence
If the fasteners are loose or improperly torqued, structural failure may result, causing unexpected movement of the digger derrick and increasing the risk of injury.
Manufacturer remedy
Altec has notified owners, and instruct them to perform the annual torque inspection, free of charge. The recall began June 2, 2016. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 633.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Other Altec Digger Derrick model years
Check your 2015 Altec Digger Derrick VIN
Not every recall applies to every VIN in a given year. Enter the 17-character VIN from your Altec Digger Derrick at nhtsa.gov/recalls to see whether your specific vehicle has an unrepaired recall.
Check an Altec VIN