NHTSA vehicle safety data
2007 Altec Digger Derrick Recalls & Complaints
The 2007 Altec Digger Derrick has 4 NHTSA recall campaigns on file as of October 21, 2026. try.vin has no NHTSA owner complaints on file for the 2007 Altec Digger Derrick. Recall repairs are usually free at an authorized Altec dealer.
NHTSA recall and complaint data for the 2007 Altec Digger Derrick. Recall data is refreshed daily from NHTSA.
Load May Fall Due to Incorrect Winch Holding Valve
NHTSA #23V636000 · Equipment — Mechanical — Winch · NHTSA notice
Reported September 14, 2023 · Altec Industries, Inc.
Potentially affected: 53 vehicles
Repair completion: 37.74% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign MAB 3113 · Owners notified September 22, 2023
Defect description
Altec Industries, Inc. (Altec) is recalling certain 2004-2023 DL42 and DL45 Digger Derricks. The incorrect hydraulic load holding valve may have been installed, which can cause the winch to lower uncontrollably and the load to fall.
Safety consequence
An uncontrolled load falling increases the risk of injury to personnel or others nearby.
Manufacturer remedy
Altec will replace the load holding valve, free of charge. Owner notification letters are expected to be mailed October 6, 2023. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is MAB 3113.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.nhtsa.gov.
Pedestal Tube may Crack
NHTSA #19V127000 · Equipment · NHTSA notice
Reported February 27, 2019 · Altec Industries Inc.
Potentially affected: 14,389 vehicles
Repair completion: 70.32% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN 713 · Owners notified April 3, 2019 · Vehicles built October 15, 2003 – February 22, 2019 (per NHTSA)
Defect description
Altec Industries, Inc (Altec) is recalling certain 2003-2019 Altec DL/DM, DL/DMB, and DC Digger Derrick vehicles. The pedestal tube welds may crack over time.
Safety consequence
Unrepaired cracks may result in failure of the pedestal and uncontrolled movement increasing the risk of injury.
Manufacturer remedy
Altec will notify owners and will provide repairs as necessary and a reinforcing kit. The recall began April 3, 2019. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 713.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Battery Equalizers-Possible Fire
NHTSA #14V503000 · Electrical System — 12V/24V/48V Battery · NHTSA notice
Reported August 15, 2014 · Altec Industries Inc.
Potentially affected: 51 vehicles
Repair completion: 29.41% (latest rate the manufacturer reported to NHTSA; dataset updated October 21, 2026)
Altec campaign CSN 603 · Owners notified October 15, 2014 · Recall influenced by NHTSA's Office of Defects Investigation
Defect description
Altec Industries, Inc. (Altec) is recalling certain model year 2000-2013 Aerial Device and Digger Derrick trucks, equipped with Sure Power Battery Equalizers containing a particular epoxy sealing, aka 'potting', compound. The specific potting compound used in the subject products for insulation was found to be capable of conducting electricity after being exposed to heat.
Safety consequence
Once electrically conductive, the material is capable of melting and burning, increasing the risk of a fire.
Manufacturer remedy
Altec will notify owners, and dealers will replace any affected battery equalizer, free of charge. The recall is expected to begin in September 2014. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 603.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Winch Drum Fracture
NHTSA #13V141000 · Equipment · NHTSA notice
Reported April 11, 2013 · Altec Industries Inc.
Potentially affected: 1,057 vehicles
Altec campaign CSN 574 · Owners notified June 10, 2013
Defect description
Altec Industries, Inc (Altec) is recalling certain model year 2007-2012 DC, and DL/DM Digger Derrick utility trucks, equipped with boom tip winches using Tulsa Winch Group (formerly Gear Products) winch drums. In the affected vehicles, the winch drum could deform or fracture.
Safety consequence
If the winch fails while in use, it could cause personal injury.
Manufacturer remedy
Altec will notify owners and dealers will replace the winch drum, free of charge. The recall began on June 10, 2013. Altec's recall campaign number is CSN 574.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Other Altec Digger Derrick model years
Check your 2007 Altec Digger Derrick VIN
Not every recall applies to every VIN in a given year. Enter the 17-character VIN from your Altec Digger Derrick at nhtsa.gov/recalls to see whether your specific vehicle has an unrepaired recall.
Check an Altec VIN