NHTSA Office of Defects Investigation
Preliminary Evaluation PE13-007: Rear Control Arm Failure
- Closed
NHTSA's Office of Defects Investigation opened Preliminary Evaluation PE13-007 on March 25, 2013 and closed it on August 20, 2013. NHTSA's investigations file lists the Hyundai Azera and Sonata for it and links recall 13V-354 to it.
Updated daily from NHTSA's investigations file
Key facts
- NHTSA number
- PE13-007 (also written PE13007)
- Investigation type
- Preliminary Evaluation The first stage of most defect investigations: NHTSA's Office of Defects Investigation gathers basic information about a possible safety defect, including from the manufacturer.
- Status
- Closed August 20, 2013
- Opened
- Closed
- Vehicle or equipment manufacturer
- Hyundai Motor America
- Component
- Suspension — Rear
- Recall linked by NHTSA
- 13V-354: Crossmember Corrosion may cause Loose Control Arm, reported
- Vehicles and equipment
- Hyundai Azera and Sonata
NHTSA's summary
As NHTSA's Office of Defects Investigation wrote it for Preliminary Evaluation PE13-007.
In a letter dated August 9, 2013, Hyundai-Kia America Technical Center, Inc. (Hyundai) notified NHTSA that Hyundaiis conducting a safety recall (13V-354) involving approximately 239,000 vehicles involving model year (MY) 2006 through 2010 Hyundai Sonata vehicles (approximately 215,000)produced beginning on March 1, 2005 through January 21, 2010 and model year (MY) 2006 through 2011 Hyundai Azera vehicles (approximately 24,000) produced beginning on September 27, 2005 through November 22, 2010 that are registered in and operated or originally sold in the following 20 salt belt states and the District of Columbia: Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, and Wisconsin.
Hyundai will also inform dealers to inspect/repair vehicles that were previously registered in salt belt states but are currently registered elsewhere. Hyundai is conducting the recall to remedy a defect involving internal corrosion of the rear sub frame that may lead to separation of the rear upper/lower control arm(s) at their respective mounting points and/or separation of the axle from the transaxle where they meet.
This could result in a loss of vehicle control and/or vehicle disablement which may increase the risk of a vehicle crash.
In response to NHTSA?s Information Request (IR) letter, Hyundai stated the Azera vehicles utilizes the identical cross member and upper/lower rear control arm components as the subject (Sonata) vehicles.
In analysis of both Vehicle Owner Questionnaire (VOQ) data submitted to the Office of Defects Investigation (ODI) and consumer complaint data submitted to Hyundai, ODI identified 19 non-duplicative reports alleging excessive corrosion of the rear sub frame. All of the complaint vehicles were either originally sold or registered at the time of the incident in one of the salt belt states.
Of these 19 reports, 9 alleged either a suspension component separation or a fracture of the vehicle's rear cross member assembly.
Similarly, ODI identified 8 warranty claims of rear sub frame replacement in data submitted by Hyundai due to excessive corrosion, all of which involved vehicles originally sold or operated in a salt belt state. Based on Hyundai's decision to conduct a safety recall, (13V-354) this investigation is closed.
The VOQs cited above can be viewed at www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following identification numbers: 10535115, 10534110, 10525976, 10524726, 10521520, 10508368, 10505463, 10490073, 10486752, 10486435, 1048354, 10473922, and 10437887.
Vehicles and equipment listed for this investigation
NHTSA's investigations file lists these vehicles and equipment for Preliminary Evaluation PE13-007. A listed model year means only that an investigation names it; it says nothing about any particular vehicle. Model years with a try.vin recall page link to that page's NHTSA investigations section.
What an NHTSA investigation is
NHTSA's Office of Defects Investigation (ODI) looks into possible safety defects in vehicles and equipment, often after owner complaints. An investigation usually starts as a Preliminary Evaluation, or as a Recall Query when it concerns whether an existing recall covers the right vehicles or fixes the problem, and ODI can upgrade it to a more detailed Engineering Analysis. A Defect Petition asks NHTSA to open an investigation, and Audit and Equipment Queries are administrative investigations into whether companies complied with federal vehicle safety requirements, such as reporting, recall and certification rules.
An open investigation is not a finding that a safety defect exists, and NHTSA can close one without a recall.
To see whether a specific vehicle has an open recall, enter its VIN at nhtsa.gov/recalls.
Hyundai VIN check: decode a VIN to see its year, make and model.
Sources
NHTSA's investigation record for PE13-007
Investigation details come from NHTSA's investigations file, which try.vin imports once a day. The investigation types are described from the U.S. Department of Transportation Inspector General's May 2023 report on NHTSA's Office of Defects Investigation, NHTSA's petition rules (49 CFR Parts 552 and 557) and NHTSA's Office of Defects Investigation procedures. How try.vin reads NHTSA investigations.