NHTSA Office of Defects Investigation

Preliminary Evaluation PE06-048: ENGINE COMPARTMENT FIRE

  • Closed

NHTSA's Office of Defects Investigation opened Preliminary Evaluation PE06-048 on October 30, 2006 and closed it on April 17, 2007. NHTSA's investigations file lists the Ford Escape and Mazda Tribute for it and links recalls 07V-156 and 07V-157 to it.

Updated daily from NHTSA's investigations file

Key facts

NHTSA number
PE06-048 (also written PE06048)
Investigation type
Preliminary Evaluation The first stage of most defect investigations: NHTSA's Office of Defects Investigation gathers basic information about a possible safety defect, including from the manufacturer.
Status
Closed April 17, 2007
Opened
Closed
Vehicle or equipment manufacturers
Ford Motor Company; Mazda Motor Corp.
Components
Service Brakes, Hydraulic — Antilock/Traction Control/Electronic Limited Slip; Service Brakes, Hydraulic — Antilock/Traction Control/Electronic Limited Slip — Control Unit/Module
Recalls linked by NHTSA
  • 07V-156: ABS MODULE ELECTRICAL WIRING HARNESS, reported
  • 07V-157: ABS MODULE ELECTRICAL WIRING HARNESS, reported
Vehicles and equipment
Ford Escape and Mazda Tribute

NHTSA's summary

As NHTSA's Office of Defects Investigation wrote it for Preliminary Evaluation PE06-048.

IN LETTERS DATED MARCH 30, 2007, FORD AND MAZDA NOTIFIED NHTSA THAT THEY WILL CONDUCT SAFETY RECALLS TO REMEDY A SAFETY DEFECT THAT MAY RESULT IN FIRE IN A WIRING CONNECTOR USED IN CERTAIN MODEL YEAR (MY) 2001-2004 FORD ESCAPE AND MAZDA TRIBUTE SPORT UTILITY VEHICLES EQUIPPED WITH ABS.RECALL 07V-156 INVOLVES APPROXIMATELY 446,450 MY 2001-2004 ESCAPE VEHICLES MANUFACTURED FROM OCTOBER 22, 1999 THROUGH JANUARY 23, 2004.

RECALL 07V-157 INVOLVES APPROXIMATELY 95,300 MY 2001-2004 TRIBUTE VEHICLES MANUFACTURED FROM APRIL 17, 2000 THROUGH DECEMBER 19, 2003. ACCORDING TO THE MANUFACTURERS, THE ELECTRICAL WIRING CONNECTORS TO THE ABS ELECTRONIC CONTROL MODULE WERE MANUFACTURED WITH WIRE SEALS MISSING OR IMPROPERLY INSTALLED IN SOME WIRING HARNESSES USED IN THE RECALL POPULATIONS.THIS MAY ALLOW ENVIRONMENTAL CONTAMINANTS SUCH AS WATER OR BRAKE FLUID TO ENTER THE ABS ELECTRICAL CONNECTOR INTERFACE AND CAUSE CORROSION OF THE ELECTRICAL TERMINALS.SUCH CORROSION MAY RESULT IN AN ILLUMINATED ABS TELLTALE, AN OPEN CIRCUIT, AND/OR AN ENGINE COMPARTMENT FIRE ORIGINATING AT THE ELECTRICAL CONNECTOR.TO REMEDY THE DEFECT, THE MANUFACTURERS WILL INSPECT THE CONNECTORS FOR SEAL INTEGRITY.IF A SEAL INTEGRITY ISSUE IS IDENTIFIED THE VEHICLE WILL BE REPAIRED AS NECESSARY.ALL VEHICLES WILL HAVE DIELECTRIC GREASE APPLIED TO THE CONNECTORS TO FURTHER REDUCE THE POSSIBILITY OF CONTAMINANTS ENTERING THE ELECTRICAL CONNECTORS. TO DATE, ODI IS AWARE OF 120 NON-CRASH RELATED FIRE INCIDENTS ALLEGED TO HAVE ORIGINATED IN THE ENGINE COMPARTMENT AT OR NEAR THE ABS ELECTRONIC CONTROL MODULE IN THE SUBJECT VEHICLES, WHICH REPRESENT APPROXIMATELY 80 PERCENT OF THE RECALL POPULATION.OF THE 120 ALLEGED FIRES, 6 ARE ALLEGED TO HAVE OCCURRED WHEN THE VEHICLE WAS PARKED INSIDE A GARAGE STRUCTURE.IN 4 INCIDENTS, COMPLAINANTS ALLEGED THE STRUCTURE OR ADJOINING STRUCTURE(S) SUFFERED SMOKE DAMAGE, WHILE IN 2 INCIDENTS, THE ALLEGED FIRES CAUSED MORE EXTENSIVE DAMAGE TOTALING APPROXIMATELY $50,000 EACH.THERE ARE NO KNOWN INJURIES OR FATALITIES RELATED TO THE ALLEGED DEFECT.BASED ON THE FORD AND MAZDA RECALLS, THIS INVESTIGATION IS CLOSED.

Vehicles and equipment listed for this investigation

NHTSA's investigations file lists these vehicles and equipment for Preliminary Evaluation PE06-048. A listed model year means only that an investigation names it; it says nothing about any particular vehicle. Model years with a try.vin recall page link to that page's NHTSA investigations section.

What an NHTSA investigation is

NHTSA's Office of Defects Investigation (ODI) looks into possible safety defects in vehicles and equipment, often after owner complaints. An investigation usually starts as a Preliminary Evaluation, or as a Recall Query when it concerns whether an existing recall covers the right vehicles or fixes the problem, and ODI can upgrade it to a more detailed Engineering Analysis. A Defect Petition asks NHTSA to open an investigation, and Audit and Equipment Queries are administrative investigations into whether companies complied with federal vehicle safety requirements, such as reporting, recall and certification rules.

An open investigation is not a finding that a safety defect exists, and NHTSA can close one without a recall.

To see whether a specific vehicle has an open recall, enter its VIN at nhtsa.gov/recalls.

Free VIN check: decode a VIN to see its year, make and model.

Sources

NHTSA's investigation record for PE06-048

Investigation details come from NHTSA's investigations file, which try.vin imports once a day. The investigation types are described from the U.S. Department of Transportation Inspector General's May 2023 report on NHTSA's Office of Defects Investigation, NHTSA's petition rules (49 CFR Parts 552 and 557) and NHTSA's Office of Defects Investigation procedures. How try.vin reads NHTSA investigations.