NHTSA Office of Defects Investigation
Engineering Analysis EA03-012: REAR BRAKE LINE FAILURE
- Closed
NHTSA's Office of Defects Investigation opened Engineering Analysis EA03-012 on July 25, 2003 and closed it on April 11, 2005. NHTSA's investigations file lists 4 models from 3 makes for it and links recall 05V-086 to it.
Updated daily from NHTSA's investigations file
Key facts
- NHTSA number
- EA03-012 (also written EA03012)
- Investigation type
- Engineering Analysis A more detailed stage of a defect investigation, opened when NHTSA's Office of Defects Investigation decides an issue merits further review, often after a Preliminary Evaluation or a Recall Query; it can include vehicle testing, surveys and further information requests.
- Status
- Closed April 11, 2005
- Opened
- Closed
- Vehicle or equipment manufacturer
- Ford Motor Company
- Components
- Service Brakes, Hydraulic; Service Brakes, Hydraulic — Fluid; Service Brakes, Hydraulic — Foundation Components — Hoses, Lines/Piping, and Fittings
- Recall linked by NHTSA
- 05V-086: BRAKE LINE, reported
- Vehicles and equipment
- 4 models from 3 makes, including the Ford Crown Victoria and Lincoln Town Car
NHTSA's summary
As NHTSA's Office of Defects Investigation wrote it for Engineering Analysis EA03-012.
try.vin does not copy NHTSA's investigation documents; NHTSA's investigation record lists the ones NHTSA has published.
IN A LETTER DATED FEBRUARY 25, 2005, FORD MOTOR COMPANY (FORD) NOTIFIED ODI THAT IT WOULD BE CONDUCTING A CUSTOMER SATISFACTION PROGRAM (FORD NO. 04B26) TO CORRECT A REAR BRAKE LINE CHAFING CONCERN IN APPROXIMATELY 44,000 MODEL YEAR (MY) 1997 FORD CROWN VICTORIA AND GRAND MARQUIS NON-FLEET VEHICLES EQUIPPED WITH ELECTRONIC TRACTION CONTROL THAT WEREBUILT AFTER MARCH 19, 1997.
THESE VEHICLES HAVE AN ADDITIONAL REAR BRAKE LINE AND A MASTIC PATCH CAUSING REDUCED CLEARANCE FROM A STIFFENING RIB IN THE FLOOR PAN.ODI?S ANALYSIS SHOWED HIGHER COMPLAINT AND WARRANTY RATES RELATED TO REAR BRAKE LINE FAILURES IN THIS POPULATION THAN IN OTHER SUBJECT VEHICLES AND PEER MID-SIZED PASSENGER CARS THAT WERE EVALUATED DURING THE INVESTIGATION.VEHICLES INVOLVED IN FORD?S PROGRAM WILL HAVE THE REAR BRAKE LINES INSPECTED FOR CONTACT WITH THE FLOOR PAN STIFFING RIB.IF THERE IS CONTACT, BUT NO ABRASION OR LEAKAGE, THE BRAKE LINES WILL BE REPOSITIONED.IF THERE IS ABRASION OR A LEAK IS EVIDENT THE BRAKE LINE WILL BE REPAIRED.IF NECESSARY, BOTH OF THE REAR BRAKE LINES WILL BE REPLACED. THOUGH FORD DOES NOT ADMIT TO A SAFETY-DEFECT IN THE SUBJECT COMPONENTS, ODI BELIEVES THAT THE FACTS IN THIS INVESTIGATION SHOW OTHERWISE BECAUSE THE INSUFFICIENT CLEARANCE IN THE ROUTING OF THOSE BRAKE LINES MAY RESULT IN LEAKS IN THOSE LINES THAT MAY RESULT IN INCREASED STOPPING DISTANCES.ODI IS DESIGNATING THE CAMPAIGN A SAFETY RECALL (NHTSA RECALL NO. 05V-086).
BECAUSE OF THE LOW RATES OF BRAKE LINE FAILURES IN THE REMAINING SUBJECT VEHICLES, A SAFETY-RELATED DEFECT HAS NOT BEEN IDENTIFIED IN THOSE POPULATIONS AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS IN THOSE VEHICLES.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.FOR ADDITIONAL INFORMATION, SEE THE ATTACHED CLOSING REPORT.
Vehicles and equipment listed for this investigation
NHTSA's investigations file lists these vehicles and equipment for Engineering Analysis EA03-012. A listed model year means only that an investigation names it; it says nothing about any particular vehicle. Model years with a try.vin recall page link to that page's NHTSA investigations section.
What an NHTSA investigation is
NHTSA's Office of Defects Investigation (ODI) looks into possible safety defects in vehicles and equipment, often after owner complaints. An investigation usually starts as a Preliminary Evaluation, or as a Recall Query when it concerns whether an existing recall covers the right vehicles or fixes the problem, and ODI can upgrade it to a more detailed Engineering Analysis. A Defect Petition asks NHTSA to open an investigation, and Audit and Equipment Queries are administrative investigations into whether companies complied with federal vehicle safety requirements, such as reporting, recall and certification rules.
An open investigation is not a finding that a safety defect exists, and NHTSA can close one without a recall.
To see whether a specific vehicle has an open recall, enter its VIN at nhtsa.gov/recalls.
Free VIN check: decode a VIN to see its year, make and model.
Sources
NHTSA's investigation record for EA03-012
Investigation details come from NHTSA's investigations file, which try.vin imports once a day. The investigation types are described from the U.S. Department of Transportation Inspector General's May 2023 report on NHTSA's Office of Defects Investigation, NHTSA's petition rules (49 CFR Parts 552 and 557) and NHTSA's Office of Defects Investigation procedures. How try.vin reads NHTSA investigations.