NHTSA vehicle safety data
1996 International Harvester 2574 Recalls & Complaints
The 1996 International Harvester 2574 has 2 NHTSA recall campaigns on file as of October 21, 2026. try.vin has no NHTSA owner complaints on file for the 1996 International Harvester 2574. Recall repairs are usually free at an authorized International Harvester dealer.
NHTSA recall and complaint data for the 1996 International Harvester 2574. Recall data is refreshed daily from NHTSA.
NAVISTAR/EATON/DRIVE AXLE HOUSING
NHTSA #96V233002 · Suspension — Rear · NHTSA notice
Reported November 22, 1996 · INTERNATIONAL TRUCK AND ENGINE
Potentially affected: 1,133 vehicles
Owners notified December 3, 1996 · Vehicles built April 16, 1996 – October 16, 1996 (per NHTSA)
Defect description
THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION.
Safety consequence
THIS LOCKING TAB PREVENTS THE WHEEL BEARING NUT FROM LOOSENING DURING VEHICLE OPERATION. IF THIS TAB IS DEFORMED, THE NUT CAN LOOSEN ALLOWING THE WHEEL TO SEPARATE FROM THE AXLE INCREASING THE RISK OF A VEHICLE ACCIDENT.
Manufacturer remedy
DEALERS WILL REPLACE THE DRIVE AXLE HOUSING NUTS WITH A CONVENTIONAL WHEEL NUT HARDWARE SYSTEM.
Notes
OWNER NOTIFICATION:OWNER NOTIFICATION BEGAN DECEMBER 10, 1996. NOTE: OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT NAVISTAR AT 1-800-448-7825.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
NAVISTAR/SUSPENSION
NHTSA #96V124004 · Suspension · NHTSA notice
Reported August 1, 1996 · INTERNATIONAL TRUCK AND ENGINE
Potentially affected: 21 vehicles
Vehicles built July 31, 1995 – March 14, 1996 (per NHTSA) · Recall influenced by NHTSA's Office of Defects Investigation
Defect description
THE EQUALIZING BEAM SHAFT OF THE TANDEM AXLE SUSPENSION WERE MANUFACTURED FROM AS-ROLLED SAE4140 STEEL RATHER THAN THE SPECIFIED ANNEALED SAE4140. THESE SHAFTS CAN FRACTURE INSIDE THE BEAM AT THE TOE OF THE WELD.
Safety consequence
VEHICLES ARE SUBJECT TO VEHICLE TILT AND POSSIBLE ROLLOVER IN THE EVENT THAT BOTH EQUALIZING BEAMS, ON THE SAME SIDE OF THE VEHICLE, EXPERIENCE A SIMULTANEOUS SHAFT FAILURE. AFFECTED SUSPENSIONS CAN ALSO DROP AND CONTACT THE ROAD SURFACE GENERATING SPARKS WHICH COULD IGNITE FLAMMABLE MATERIAL.
Manufacturer remedy
OWNER NOTIFICATION IS BEING CONDUCTED BY NEWAY ANCHORLOK. DEALERS WILL INSPECT AND REPLACE ALL SUSPENSION SUSPENSION BEAMS WITH SUSPENSION BEAMS CONTAINING APPROPRIATE SHAFTS.
Notes
OWNER NOTIFICATION:OWNER NOTIFICATION IS BEING CONDUCTED BY NEWAY ANCHORLOK AND BEGAN JULY 18, 1996.NOTE:OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT NEWAY AT 1-800-237-8932.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
Other International Harvester 2574 model years
Check your 1996 International Harvester 2574 VIN
Not every recall applies to every VIN in a given year. Enter the 17-character VIN from your International Harvester 2574 at nhtsa.gov/recalls to see whether your specific vehicle has an unrepaired recall.
Check an International Harvester VIN