2022 Winnebago Ekko Recalls & Complaints

Incident: August 2, 2026 · Filed: September 12, 2026

Following recall repairs for NHTSA ID Number: 24V541000, melting wires were noticed coming out of the roof solar port. These are approximately 6” of 10 gauge wires taking current from the solar roof port to the upgraded wiring from the previous recall. This section of 10 gauge wiring is undersized for the peak electrical load.

Incident: June 7, 2026 · Filed: June 20, 2026

I am the owner of a 2022 Winnebago Ekko. My vehicle is subject to NHTSA Recall 24V-024 (Winnebago Campaign #181) regarding the Blind Spot Monitoring (BSM) system. I am writing to request your guidance on how to proceed, as I am currently unable to obtain the required safety remedy. My local authorized dealer, has declined to open a repair order, stating that their internal system marks the recall as 'closed' due to a previous service campaign (74-05). Despite providing them with the official NHTSA Dealer Notification for Campaign #181, which clearly states this recall supersedes the previous campaign and must be performed regardless of ownership, they have refused to diagnose the system. Could you please provide guidance on the appropriate next steps to ensure this safety mandate is honored, or advise if there is an escalation process I should follow with the manufacturer to resolve this impasse? I am concerned about the safety risk of operating a vehicle with a known, failing BSM system and would appreciate your assistance in rectifying this." I took the vehicle on vacation last week. My wife drove while I navigated. The BSM worked well. After we arrived and were driving in heavy traffic we noticed the BSM wasn't indicating when lane changes were unsafe. Ive read on user forums that rain has affected their BSM units. I contacted Winnebago Customer Care prior to this, who wrote "From: Winnebago Motorhome Customer Care <[XXX]> Date: Thursday, June 18, 2026 at 9:46 AM To: Redacted Subject: Case:[XXX] Blind Spot Assist issue with Winnebago Ekko Hello, All recalls are complete for this coach. If the owner is experiencing issues it must be brought back to the repair dealer to diagnose the issue. Any warranty is given from the repairing dealer. As the dealer that performed the work is in Indiana & I am in Arkansas. It would be very inconvenient although If necessary I would try that too. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Incident: November 1, 2025 · Filed: November 2, 2025

The Balmar alternator installed on our RV, which provides electrical power to charge the coach battery started a noticeable whine at idle, it stopped providing a charge to the coach battery, and upon further inspection, after opening the hood, we noticed a faint burning electrical smell. To confirm that the Balmar alternator was failing, I checked its electrical output to the battery, and it was not charging. I then proceeded to unplug the regulator for the alternator to see if the whine and smell were still present. They were not. Since the whine was not present with the Balmar alternator unplugged, the burning smell had dissipated, and no charge coming from the alternator when plugged in, I determined it was starting or already failed. Knowing that there have been multiple reports from other owners that their EKKO's caught fire or had severe smoke coming from the engine compartment, that was later found to be the Balmar alternator, I made the decision to leave it unplugged. I was concerned about our safety and the real possibility of a fire if we continued with it plugged in and running. This just happened to us so we have not had it looked at by a dealer or independent service center yet, but we could make it available for inspection upon request. Please note, this is the second Balmar that has failed on us in our four year ownership of this RV, and we have a friend that has had five Balmar's fail on him! Winnebago needs to be held accountable and should be required to remove and replace the Balmar alternator from all owners RV's and replace it with a more suitable and capable alternator that will provide the secondary power they advertise when they sell this model to consumers.

Incident: October 10, 2025 · Filed: October 11, 2025

October 10, 2025. The vehicle is a 2022 Winnebago EKKO RV on a 2021 Ford Transit with 49,000 miles. The incident occurred after driving the vehicle for about 5 minutes with outside temperatures around 50 degrees Fahrenheit and noticed an unusual high pitch whine. When I opened the hood the Balmar MC-618 Alternator unit was extremely hot, smoking, and had a strong burning smell. Since the EKKO models have had numerous reports of secondary alternator/Balmar malfunctions I knew enough to disable the alternator by unplugging the 4 pin connector on the Balmar 618 regulator before traveling any further. The following morning I plugged the Balmar unit back in and the whining sound and burning smell immediately returned. There is a NHTSA Safety Recall 23V-234, Campaign # 174 EKKO 12V Charging System, sent out by Winnebago for this very safety issue due to fires. This recall was completed during the time that the original owner had this 2022 Winnebago EKKO (prior to our purchasing this 2022 Winnebago EKKO in June 2024). There have been numerous failures on Balmar units that have had the campaign #174 recall completed, including ones performed at the factory. The Winnebago fix is obviously not working and is still an extreme fire issue.

Incident: July 20, 2025 · Filed: September 17, 2025

SUMMARY: Propane leaks from outside LP hose when factory zip-tie failed resulting in LP hose detached and damaged from rubbing against the tire. 2022 Winnebago EKKO. DETAILS: RV has a LP hose that routes above the passenger side rear tires from the propane tanks to other locations of the RV. This hose was held back from the rear tire at two locations each with a thin metal tab and a single plastic zip-tie. One of the zip-tie failed, resulting in the LP hose rubbing on the tire when driving. The rubbing made a hole on the hose and propane leaked from the hole. I was cooking next to the RV at a campground when propane was leaking from the damaged hose. The leak could have caused an explosion and serious injury to anyone nearby. The design to use plastic zip-tie to keep the LP hose from the tires is unsafe. I have taken photos of the damage and reported this incident to Winnebago customer service via email on 9/11/25. This issue was not reported to the police or insurance company due to no injury. Prior to the propane leak there was no warning or message or other symptoms of the problem. Problem first appeared during a camping trip in late July 2025 when I was camping at White River campground in Mt Rainier National Park in WA.

Incident: July 6, 2025 · Filed: July 8, 2025

The front driver side tire (Hankook Dynapro HT 205/75R16) on our RV suddenly caused a wobbly ride while driving. Upon close inspection we noticed a bulge which had formed on the tread of the tire. We then noticed a large part of the side wall and tread to start separating on the inside of the tire. A technician at the tire store advised us to replace the tire immediately.

Incident: March 1, 2025 · Filed: March 27, 2025

This is to report a failure after NHTSA campaign number 23V234000 was addressed by Winnebago through their campaign number 174. I had the fix performed by Winnebago at their factory service center about 20k miles ago and the alternator failed again with the exact same symptoms. This is my 5th alternator failure in 60,000 miles and 3 years.

Incident: February 3, 2025 · Filed: February 3, 2025

1The stock Balmar alternator failed on or around [XXX]. That alternator was replaced on or about November 22, 2022 by a certified Winnebago service center in Connecticut. 2The second failed on or about [XXX] following Service Campaign 7303 work performed at Forest City. It was replaced under the 174 recall on or about February 7, 2024 at a certified Winnebago service center in Las Vegas.  3The third alternator failed on or about [XXX]. 4The fourth was installed October 7, 2024 by a certified Winnebago service center in New Jersey. 5. The fourth alternator failed sometime between [XXX] and [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Incident: December 13, 2024 · Filed: December 15, 2024

The vehicle is a 2021 Ford Transit with a 2022 Winnebago Ekko RV. The incident occurred when I started the engine and noticed an unusual high pitch whine. When I opened the hood the Balmar unit was extremely hot with a strong burning smell. Since the Ekko models have had numerous reports of secondary alternator / Balmar malfunctions I knew enough to disable the alternator by unplugging the 4 pin connector on the Balmar 618 regulator before traveling any further. The following morning I plugged the Balmar unit back in place to see if the high pitch sound reoccurred. The sound immediately returned and I used my infrared thermometer which read 438 degrees Fahrenheit on the Balmar alternator. The Lithionics battery app indicated the batteries were 90 percent full but would no longer charge, leaving me only shore power to recharge the batteries. There is a NHTSA Safety Recall 23V-234, Campaign # 174 Ekko 12V Charging System, sent out by Winnebago for this very safety issue due to fires. We had this recall completed at the Forest City Iowa Winnebago factory in April of 2024. There have been numerous failures on Balmar units that have had the campaign #174 recall completed, including ones performed at the factory. The Winnebago fix is obviously not working and is still an extreme fire issue.

Incident: November 21, 2024 · Filed: November 21, 2024

The Winnebago factory installed secondary alternator (manufactured by Balmar) responsible for charging the batteries in my motorhome started to whine and overheat. Luckily the week prior, I had read about another EKKO owner experiencing the same symptoms before it created enough smoke that caused the driver to immediately pull off the road and extinguish the engine bay with a fire extinguisher. In an effort to avoid that, I disconnected the Balmer until it was able to be replaced. This original problem was supposed to be addressed in recall 174. Over a year later the recall supposedly addressed the issues by moving the regulator out of the engine bay, replacing the Balmer and a major reworking of the electrical system. After multiple components failed during the recall repair, my EKKO took over 6 weeks to get a working solution at a Winnebago dealership. That was a year ago. 10 days ago the same symptoms of whining and overheating returned resulting in me returning to the same dealer with them diagnosing the Balmer as defective and a health risk. Had I not disconnected the Balmer it would’ve overheated and resulted in melting the primary drive belt and potentially damaging the engine and other major components as documented by numerous other EKKO owners.