NHTSA vehicle safety data

2013 Kenworth T600 Recalls & Complaints

The 2013 Kenworth T600 has 1 NHTSA recall campaign and 2 owner complaints on file as of November 3, 2026. Recall repairs are usually free at an authorized Kenworth dealer.

NHTSA recall and complaint data for the 2013 Kenworth T600. Recall data is refreshed daily from NHTSA.

2013 Kenworth T600 owner complaints

Owners have filed 2 complaints with NHTSA about the 2013 Kenworth T600, describing incidents dated November 28, 2012 to July 8, 2016.

Most-cited components

  • Latches/Locks/Linkages 1 complaint
  • Service Brakes 1 complaint
  • Structure 1 complaint

Of the 2 complaints on file, 1 reports a crash (owner-reported, not verified by NHTSA).

Newest complaints

  • ODI #10888447 · Filed

    TL* THE CONTACT OWNS A 2013 KENWORTH T600. WHILE ATTEMPTING TO EXIT THE VEHICLE, BOTH THE PASSENGER AND DRIVER DOORS FAILED TO OPEN. EVEN USING THE KEY FAILED TO OPEN THE DOORS. THE VEHICLE WAS TAKEN TO A DEALER WHERE IT WAS DIAGNOSED THAT THE LOCKING MECHANISM IN THE DOOR FAILED AND NEEDED TO BE…

  • ODI #10486425 · Filed

    DIFFICULT BRAKING WHEN RESTING RIGHT FOOT IN MIDDLE OF FLOOR BOARD DURING A SUDDEN STOP , MOVING FOOT FORWARD IT HITS TRIM THEN SIDEWAYS TO CONTACT BRAKE PEDAL IN MIDDLE UNABLE OBTAIN ENOUGH PRESSURE TO APPLY BRAKES DAMAGED A OVERHEAD DOOR IT'S MY UNDERSTANDING TWO COWORKERS ALSO EXPERIENCED SIMILAR…

Read all 2 complaints

Half-Round Driveline Cap Screw Torque

NHTSA #12V407000 · Power Train — Driveline · NHTSA notice

Reported August 20, 2012 · PACCAR INCORPORATED

Potentially affected: 535 vehicles

Manufacturer campaign 12KWF · Owners notified September 7, 2012

Defect description

Paccar is recalling certain model year 2013 kenworth T400, T600, T700, T800, and W900 vehicles, manufactured from July 18, 2012, through August 10, 2012. Cap screws securing the main driveline to the forward rear axle and cap screws on the inter-axle driveline may not have been properly torqued.

Safety consequence

Fasteners which are not properly torqued to specification can result in the driveline separating from the vehicle, disabling the vehicle and increasing the risk of a crash. The separated component could also become a road hazard.

Manufacturer remedy

Paccar will notify owners, and dealers will inspect and re-torque the each of the affected fasteners, free of charge. The safety recall began on September 7, 2012. Owners may contact Kenworth at 1-425-828-5440.

Notes

Kenworth's recall number is 12KWF. Owners may contact the National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236 (TTY: 1-800-424-9153); or go to http://www.safercar.gov.

Other Kenworth T600 model years

Check your 2013 Kenworth T600 VIN

Not every recall applies to every VIN in a given year. Enter the 17-character VIN from your Kenworth T600 at nhtsa.gov/recalls to see whether your specific vehicle has an unrepaired recall.

Check a Kenworth VIN