2010 Harley-Davidson Fxdwg Recalls & Complaints

Incident: August 15, 2011 · Filed: February 5, 2013

ALL HARLEY DAVIDSON MODELS WITH 96 CUBIC INCH MOTORS HAVE THESE ISSUES: THE CRANKSHAFT ASSEMBLY ON TWIN CAM 96 CUBIC INCH MOTORS IS KNOWN TO SHIFT OR SCISSOR AROUND THE CRANK PIN AND CAUSE THE CRANKSHAFT ENDS TO HAVE EXCESSIVE RUNOUT. THIS IN TURN CAUSES EXCESSIVE VIBRATION THROUGHOUT THE ENTIRE MOTORCYCLE. IT ALSO PUTS EXCESSIVE WEAR AND TEAR ON THE DRIVELINE, AS WELL AS THE OIL PUMP. THIS WILL EVENTUALLY LEAD TO CATASTROPHIC ENGINE FAILURE AND MOST LIKELY DEATH. ALSO, HARLEY DAVIDSON DYNA MODELS ARE AFFECTED BY A CONDITION CALLED "REAR STEER". THIS CONDITION IS CAUSED WHEN TURNING THE MOTORCYCLE. THE MOTORS ARE RUBBER MOUNTED, BUT ONLY HAVE ONE STABILIZING LINK TO PREVENT THE MOTOR FROM TWISTING IN THE FRAME. THIS IS INADEQUATE. THE MOTOR CAN TWIST RIGHT TO LEFT RELATIVE TO THE DIRECTION OF TRAVEL, AND SINCE THE REAR WHEEL IS DIRECTLY ATTACHED TO THE MOTOR BLOCK VIA THE SWING ARM, THE REAR WHEEL WILL ALSO TURN RIGHT OR LEFT RELATIVE TO THE DIRECTION OF TRAVEL. THIS CAUSES THE REAR OF THE MOTORCYCLE TO TURN IN THE OPPOSITE DIRECTION OF INTENT, AND CAN HAVE DEADLY CONSEQUENCES. THIS CONDITION IS FIXED IN HARLEY'S OWN SPORTSTER LINE. ALL SPORTSTERS WITH RUBBER MOUNTED MOTORS (2004 AND UP) HAVE THREE STABILIZING LINKS TO PREVENT REAR STEER, YET NO DYNA MODEL HAS THESE LINKS! THIS MAKES DYNA MODELS VERY UNSAFE TO DRIVE. DUE TO THE "REAR STEER" PHENOMENON, AND THE CRANKSHAFT SCISSORING PHENOMENON, THE HARLEY DAVIDSON DYNA MODELS WITH 96 CUBIC INCH MOTORS ARE A RECIPE FOR DISASTER. THE ONLY FIX IS TO HAVE HARLEY DAVIDSON REPLACE THE CRANKSHAFTS WITH FORGED CRANKSHAFTS AS FOUND IN SEVERAL AFTERMARKET PRODUCT LINES, AND TO INSTALL THE REMAINING TWO STABILIZING LINKS, ALSO FOUND IN THE AFTERMARKET ARENA. *TR

Incident: April 21, 2010 · Filed: May 20, 2012

THE TIRES MOUNTED ON THESE MOTORCYCLES DUNLOPS GT502 ARE OF LOW QUALITY LASTING LESS THAN 4000 MILES AND PEELING. PLEASE RESEARCH ON THIS AS MANY MOTORISTS HAVE COMPLAINED ABOUT THIS, IN MANY FORUMS A FELLOW NEIGHBOR OWNED THE SAME MACHINE THAT I HAVE AND THEY REPLACED HIS BOTH TIRES. THAT WAS NOT MY CASE BUT THE CONDITIONS WERE THE SAME. *TR

Incident: August 15, 2009 · Filed: December 15, 2009

TL* THE CONTACT OWNS A 2010 HARLEY-DAVIDSON TRI-GLIDE(NA). THE ENGINE EXPELS EXCESSIVE EXHAUST AND HEAT THAT BURNED HER LEGS AND CLOTHES. SHE HAS PHOTOGRAPHS DISPLAYING THE BURNS. HER LEGS WERE POSITIONED CORRECTLY ON THE MOTORCYCLE. THE FAILURE OCCURRED IN WEATHER WITH TEMPERATURES ABOVE 80 DEGREES. THE MANUFACTURER AND DEALER WERE NOTIFIED, BUT NO ASSISTANCE WAS PROVIDED. THE CURRENT MILEAGE WAS APPROXIMATELY 4,000. THE FAILURE MILEAGE WAS 1. UPDATED 02/18/10. *LJ THE CONSUMER STATED THE HEAT WAS COMING FROM THE PIPES. THE CONSUMER STATED SHE WAS FEELING SO MUCH FEET FROM THE PIPES, SHE HAD TO RAISE HER FEET UP IN AN UNSAFE MANNER. THE CONSUMER WAS INFORMED BY THE DEALER IT WAS AN ONGOING PROBLEM, BUT THEY WERE NOT AUTHORIZED TO MAKE ANY MODIFICATIONS TO THE BIKE WITHOUT THE CONSENT OF CORPORATE HEADQUARTERS. A FAN WAS ORDERED TO HELP COOL THE MOTOR DOWN, BUT WHEN THEY WENT TO PUT IT ON THE BIKE, IT WOULD NOT FIT THE TRIGLIDE WITHOUT ADDITIONAL REMOVAL OF NECESSARY EQUIPMENT THAT WAS STANDARD ON THE BIKE. UPDATED 10/05/10