2024 Grand Design Imagine Recalls & Complaints

Incident: August 28, 2026 · Filed: August 31, 2026

On XXX, I was towing my 2024 Grand Design Imagine AIM travel trailer, VIN [XXX], on the freeway at highway speed behind a 2025 Ram 1500 Crew Cab using a hitch equipped with sway control bars. After the trailer crossed a bump in the road surface, it began swaying side to side and the oscillation grew uncontrollably within seconds despite the sway control. The trailer rolled over and was destroyed. It is a total loss. [Add: injuries, if any / no injuries.] This was not an isolated event. From the time of purchase the trailer exhibited poor towing behavior, including a tendency to sway and wander that was noticeably worse than other trailers I have towed with the same truck. I believe there may be a defect in the trailer's axle alignment, suspension, or weight distribution as built that made it unstable at highway speed. The tow vehicle is rated well above this trailer's gross weight, and the sway control equipment was in use, so I do not believe tow vehicle capacity or the absence of sway control explains the loss of control. I am aware NHTSA recall 23V-151 addressed incorrect tire size and inflation pressure information on the Federal Certification Label of 2023 Imagine AIM units built Nov 2022 to Feb 2023, with a stated risk of tire failure and loss of control. My unit is a 2024 and is outside that VIN range, but I am concerned a related tire, label, or chassis issue may exist on later units. I am requesting that NHTSA investigate whether the Imagine AIM single-axle platform has a stability, alignment, or tire defect that contributes to sway and rollover. I am attempting to preserve the trailer for inspection and can provide photos of the axle, spring hangers, hitch, and tires, along with purchase and service records, on request. --- Two notes. If a dealer ever documented a towing complaint or inspected the axle, add a se INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Incident: March 10, 2026 · Filed: April 17, 2026

Faulty panel wiring but everything works on shore and truck power. Called Grand Design (case #00996054) and was told it was a bad LiFEPO4 battery . I open the distribution panel and the schematic shows I should have 2 red wires (one to converter and the other to the battery) but I only have 1. Solution: Issue was in the original wiring from the factory. I called GD again and tech noticed the red wire was there but incorrectly connected to the DC fuse panel side (essentially bypassing the converter) as "battery disconnect." For my sanity I spent $165, not reimburseable per GD, and had a RV service tech come out and confirm the wiring was now correct and was told once I got a new battery everything will work as intended. I purchased new smart LiFePO4 and now all 12V equipment works as it should both on and off shore power. In conclusion, I've had no battery power once both the OEM and replacement LiFePO4 batteries went dead because they were "NEVER/EVER" being charged since the batteries were "NOT CONNECTED". This meant the battery disconnect never functioned from the beginning and when the RV battery disconnect is switched to "off," it severs the connection between the battery and the RV's 12-volt DC system and therefore the battery will not power appliances or charge when connected to shore power. By connecting an RV battery directly to the 12V DC panel (bypassing the converter) means the battery becomes the sole power source for all 12-volt appliances. Issues: Limited power duration--12V items will run until the battery drains, which can happen in a few hours/days depending on usage. No automatic charging--The battery will not be recharged, as the converter is not in the loop. Once the battery dies, you will lose all 12V power. Safety risk--The battery is likely connected to the panel without a battery disconnect switch or proper fuses, creating a potential fire hazard if a short occurs.

Incident: March 26, 2025 · Filed: March 26, 2025

Purchased brand new 2024 Grand Design Imagine XLS 17MKE on Feb 8, 2025. Have taken trailer out twice for three days in the local area to perform operational testing of the travel trailer before traveling outside of the area. Dust caps on bearing axle came loose so took trailer in for inspection. Repair shop found that all hubs were empty of grease and castle nuts were loose, hubs have extensive heat discoloration as well as bearing play, travel trailer will need new bearings, hugs and bearing races. This is a brand-new trailer, and this could have ended in catastrophic consequences causing a serious or fatal accident. When purchasing a new travel trailer the assumption is made that the axles should be quality inspected and good to operate. I have now read on group forums that this has happened to others. This needs looked into asap.

Incident: November 3, 2024 · Filed: November 4, 2024

The contact owns a 2024 Grand Design Imagine. The contact stated that while removing the spare tire secured under the RV, the contact noticed that the spare tire crank assembly wire attaching the spare tire to the RV had frayed. The contact was concerned that the frayed wire could cause the spare tire to detach while driving. The RV was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was made aware of the failure and referred the contact to the dealer. The failure mileage was approximately 1,000.

Incident: May 20, 2024 · Filed: October 9, 2024

In September 2023, we purchased our 2024 Grand Design Imagine AIM RB travel trailer. We started receiving trailer brake warnings on our truck immediately after purchasing the camper and brought it back to the dealership. The service technicians assured us that there were no issues with the brakes. In January 2024, the brakes locked up and started burning while we were driving on [XXX] in the Phoenix metro area. We had the camper towed to an authorized service dealer in Surprise, AZ, where the brakes were replaced and a switch was installed to prevent the solar panels from overloading the battery. The brakes continued to be an issue despite being sent on our way with assurances that the brakes were working. While traveling, we realized that our brakes were not functioning and were cold to the touch even after using them during travel. In February, we heard loud, metallic clanking from the right side of the brakes and returned to a dealership in Tucson, Arizona, for repair . The service manager shared that the right brake was burned up and pieces had broken off inside the drum. They replaced the brakes so that we could safely move on. Traveling from Tucson, Arizona, to Albuquerque, New Mexico, we again discovered that the right side brake was not functioning so we found a storage facility and put the trailer into storage so we could travel safely. We again contacted Grand Design and schedule service for the brakes for May 2024. Again, the service department replaced the brakes and assured us that the issue was resolved. It was not. Traveling from Albuquerque, New Mexico, to our home in Pagosa Springs, Colorado, we found that the brakes on the right side of the trailer were not working and were cold to the touch. Travelling without functioning brakes represents a serious risk to our safety as well as the safety of other travelers. We still have no resolution from Grand Design. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)